Stovax Studio 22 manual Apply a plaster finish to the chimney breast

INSTALLATION INSTRUCTIONS

INSTALLATION

15

AR2134

•Put vertical studwork at minimum clearance to the side of the fire (50mm)

• Secure to the vertical studwork through the holes in the metal brackets fitted to the fire, Diagram 16

The kit has been designed so that non-combustible board can be taken right up to the edge of the four brackets, Diagram 17

16

AR2133

17

Build the studwork chimney breast to the desired size:

•Ensure all clearances to combustible material are maintained, Section 3, 3.1 above

•Decide on flue requirements

•Cut a hole for the flue exit - see Installation

Instructions, Flue Assembly

18

AR1902

•Fit non-combustible board to the studwork above and to the sides of the fire. This should extend a minimum of 400mm above the appliance and a minimum of 50 mm to each side

•Fit plasterboard to the remaining chimney breast front

•Connect the flue system and gas services using the opening in the side of the chimney breast for access

After commissioning, finish the sides of the chimney breast, Diagram 19

19

A

Detail A

AR1911

•Apply a plaster finish to the chimney breast

AR2085

20