Stovax Studio 22 manual Safety Precautions, Installation of the appliance

Page 16

INSTALLATION INSTRUCTIONS

INSTALLATION

IMPORTANT: REFER TO DATA BADGE AND TECHNICAL SPECIFICATION AT THE FRONT OF THE MANUAL TO ENSURE THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF USE.

FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SECTION 10, SERVICING, ‘REPLACING PARTS’.

1.SAFETY PRECAUTIONS

1.1For your own and other’s safety, you must install this fire according to local and national codes of practice. Failure to install the fire correctly could lead to prosecution:

Read these instructions before installing and using this fire.

1.2These instructions must be left intact with the user.

1.3Do not attempt to burn rubbish on this appliance.

1.4Keep all plastic bags away from young children.

1.5Do not place any object on or near to the appliance and allow adequate clearance above the appliance.

IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE APPLIANCE.

2. installation of the appliance

REFER TO THE SITE REQUIREMENTS SECTION FOR ALL FLUE OPTIONS.

This stove is suitable for top or rear flue exit.

For top exit, read Section 8.2

For rear flue exit, read Section 8.1

THERE IS AN OPTIONAL DUCT KIT, CODE No. 8572

WHICH CAN BE FITTED AT THE SAME TIME AS THE APPLIANCE INSTALLATION.

2.1• Remove the appliance from the carton and discard all unnecessary packaging

Ensure no components are thrown away when unpacking

2.2To open the glass door, use the allen key provided:

Slide the allen key into the gap between the door and frame and locate the catch of the upper lock

Push the allen key DOWN

Slide the allen key into the gap and locate the lower lock

Push the allen key UP

1

AR2119

AR2119

• Open the door outwards

2.3The gas supply enters the fire through a silicon panel on the floor or in the back panel of the fire, underneath the control unit, Diagram 2

2

AR2130

AR2130

2.4To access the gas pipe:

• Undo the clips on the upper inside holding the vermiculite side panels in place, Diagram 3

3

Vermiculite side panel

AR2127

Remove the two side panels and back panel and put to one side

Ensure the back panel is supported when removing the side panels

TAKE CARE WHEN HANDLING THE VERMICULITE PANELS, THEY ARE FRAGILE.

16

Image 16
Contents Studio Covering the Following Model Studio 22 Balanced flue 8704BFLEC P8704BFLECFail FLUE CHECKGAS CHECK MAN Mode Increasing TemperatureDecreasing Temperature GeneralTemp Mode Timer ModeLOW Battery Setting the TimeChanging the Studio Batteries Cleaning the StudioAll models Advice on Handling and Disposal of Fire Ceramics Arrangement of Fuel BEDHOT SURFACES Fire will not LightTechnical Specification Covering the Following ModelsStudio 22 BF 8704BFLEC P8704BFLEC CATPacking Checklist Qty Description Fixing Kit containingProfil Frame Dimensions Size mm Steel Frame Dimensions Size mmBauhaus Frame Dimensions Size mm SITE REQUIREMENTS Flue and Chimney RequirementsFlue Options Rear ExitTOP Exits TOP Flue UP & OUT KITTOP Flue Vertical KIT 8524/8524AN TOP Flue Vertical Offset KIT 8530/8530ANExtra Flue Lengths GAS SupplyAppliance Location Safety Precautions InstallationInstallation of the appliance AR2117 Stud Work Installation Distance to Combustible MaterialFlue system see Installation, Flue Assembly SlipsApply a plaster finish to the chimney breast Studwork for Cool Wall Installation KIT Flue Assembly Wall Thickness MIN MAXTOP Exit Vertical & Horizontal Flue TOP Exit Vertical Including OffsetAssembling the Appliance Add 10 mm to the outlet endArrangement of Fuel BED AR02123 Thermostatic Remote Control Lighting the StudioCommissioning CommissioningServicing / Fault Finding Charts Symptom Cause RemedyServicing Requirements CheckIgnition Functional Check Flame Failure Functional CheckReplacing Parts Window Frame AssemblyGeneral Decorative FrameVermiculite Panels MaIN Control AssemblyMaIN Burner Pilot Burner Bracket Pilot Unit AssemblyElectrode Ignition Lead GAS ValvePilot Injector ThermocoupleMagnetic safety valve Control BOXMain injector Primary Aeration PlatePressure and Leak Testing the Appliance Follow , Main Control AssemblyShort Spares List Studio Component1ST Service 3RD Service5TH Service 7TH ServiceMember of the Stovax Group