Honeywell LYNXR-EN, LYNXR Series setup guide Delete serial number

✻83 Enhanced Sequential Mode

		Serial number	This prompt can be used to enroll the transmitter serial number via
Ib
	zz	Enter transmitter’s 7- digit serial number via RF	RF transmission or manually. If using the RF Learning Mode there
			is no need to manually enter a serial number. Proceed directly to RF
		learning or manually.	Learning. Upon entering the Serial Number mode, the Zone
		[#] = return to (1A) prompt and reject whatever	Descriptors will be announced.
		serial number entries have been made.	Note: BR type devices can be enrolled only by transmission from BR
Ib		[✻] = return to (1A) prompt (if a valid serial	devices. Likewise, UR and RF devices can only be enrolled by
		number has been enrolled, “L” is displayed	transmission from a UR or RF device
		and the serial number will be copied into	RF Learning - Two (2) transmissions (2 key depressions) at least
		EEROM and the last serial entered buffer.	five seconds apart, will be required for BR type or four (4)
			transmissions (fault, restore and fault, restore) for UR or RF type. If
		Note: For zones 26, 30, 34 and 38 only BR type	the learned serial number has a different loop number than that
			entered in ✻56 the system will announce the Voice Descriptor, if it
		devices can be used.
			is programmed, followed by two beeps and will return to Prompt (1A)
			and “L” will be displayed.
			If the loop number captured by RF transmission and that entered in
			✻56 mode match, the system will announce the Voice Descriptor, if it
			is programmed, followed by three beeps and return to Prompt (1A)
			and “LC” will be displayed. No additional transmissions are needed
			for confirmation.
			Manual Entry - Enter the 7-digit serial number printed on the
			transmitter. If you enter an incorrect digit, press the [#] key to
			backup to prompt (1A) and start over. When all 7 digits are entered,
			press the [✻] key. If less than 7 digits are entered, the keypad will
			emit a single long beep and return to the (1A) prompt without
			displaying the “L”.
			If more than 7 digits have been entered, the first 6 digits will be
			saved along with the last digit that was entered (entering 123456789
			yields the serial number 1234569).
			Note: If 52 seconds pass and no entry has been made, the system
			returns to prompt (1A).
		Delete serial number	This function deletes only the serial number.
F
		0 = discard the delete request	Entering a “9” at prompt (1A). Confirmation of the delete request will
		1 = confirm requested delete	cause deletion of the serial number pertaining to the zone being
		Note: Entering a “9” at prompt (1A) will cause the	programmed.
		panel to return to prompt (1A) regardless of
		the confirmation answer.

Note: In Enhanced Sequential Learn Mode, 4 button type keys will always be learned simultaneously. They will be stopped at the 4 button boundaries of 26, 30, 34 and 38, provided the zone is free of a serial number. If the first zone of the key has a serial number learned, the remaining keys cannot be programmed in sequential learn mode. In addition, if the zone has not been set up (duplicate loop, missing zone type, etc.) only entries 0 (skip to the next zone) and 4 (copy the key template) will be allowed.

–37–