D1265 Owner's Manual Part II: System Commands
6.Move through this list by pressing the Next Pt button.
The display changes to show the information for that point.
Press the Exit button to return to the ### points remain to be tested screen before continuing with the walk test.
7.When all points have been tested, 0 points remain to be tested is shown.
Press the Exit button.
The display momentarily shows All points have been tested.
The display then shows idle text.
Reset Sensors (CMD + 4 + 7)
Description
Detection devices, such as smoke detectors and shock sensors, must be reset after being activated. This function momentarily removes power from these sensors to reset them.
Using Reset Sensors
1.Ensure the display shows disarmed idle text.
2.Press the CMD button. The display shows *System Command*.
3.Press the 4 button, followed by the 7 button.
If you prefer, you might use the function list in place of Steps 2 and 3 to initiate this function.
Press the Menu button to enter the function list.
Press the Next button repeatedly.
When you reach the Reset Sensors button, press it.
4.The display shows for approximately 15 sec.
While the sensors reset, the keypad resets before it returns to idle text.
If you enter this function and the detector or sensor resets momentarily, but then returns to a faulted condition, the conditions causing the activation might still be present or the detector might be faulty. Check to be certain that there is no smoke, fire, or other danger present. If you can’t reset the detector or sensor, contact your security company.
Bosch Security Systems, Inc. 9/10 | 25 |