D1265 Owner's Manual Part III: Advanced Commands
4.When the display shows ### points remain to be tested you can begin. (### is the number of points).
Test each point by first activating the detection device to fault the point.
If you know the point number, you can enter it by pressing its number button and then the ENTER button.
The display changes to show the point that was entered. If the point is invalid the message “Invalid Point” or “This is not a valid walk point” appears.
5.As you fault each point, your keypad shows the point text for 60 sec and ring the fire sounders for 2 sec. This verifies that the detection device is working properly. Your system automatically resets smoke detectors.
When a resettable point (such as a smoke detector) is faulted, the display shows Sensors…resetting…please wait… for 5 sec. During this time power is removed from smoke power relays.
Faulting a point more than once will not increment the test count. However, the keypad emits a brief tone and shows the point text each time you fault the point allowing you to test multiple devices assigned to one point.
6.When the point has been tested, the display changes to show SMOKE DETECTOR tested.
7.During the Fire Test you might want to refer to the points that remain untested by pressing the View untested pts button.
The display shows ### pts untested.
Press the Point information button to see information about specific points that have not yet been tested.
The display changes to show the information for that point.
Move through this list by pressing the Next Point button.
Press the Exit button to return to the ###
points remain to be tested before continuing the Fire Test.
8.When all
Press the Exit button.
The display momentarily shows All points have been tested before returning to idle text.
56 | Bosch Security Systems, Inc. 9/10 |