4 | Getting Started | Installer Guide |
|
|
A. Typical Appliance System
NOTICE: Illustrations and photos reflect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual
Noncombustible roof flashing maintains minimum clearance around pipe Section 10
Ceiling firestop on floor of attic Section 8
Vent Pipe
Sections 7, 8, 10 
Framing/Steel Stud Assy
Section 5
Vertical Termination Cap
Section 10
Storm Collar
Section 10
Vent pipe penetrates roof, preverably without affecting roof rafters.
Section 8
Attic insulation shield (not shown) must be used here to keep insulation away from vent pipe if attic is insulated. Section 8
Framing headed off
in ceiling joists
Section 8
Hearth Extension
(not required)
Gas Line
Section 12
Figure 4.1 Typical System
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged appliance or vent system component.
•Modification of the appliance or vent system.
•Installation other than as instructed by Hearth & Home Technologies.
•Improper positioning of the decorative steel log assembly or the glass door.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
20 | Heat & Glo • LUX60 • |