H. Install RF4-8
The
Îstorm collar (Sections 10.F and Section 10.G.)
Pipe must be supported within 12 inches of the roofline using plumbers strapping or an
SECURE WITH 4
SCREWS NO LONGER
THAN 1 IN. (25 MM)
Figure 10.15 Secure Pipe with SLP-FS
•Trim the rubber boot (using scissors or a utility knife), cutting along the marked measurement lines. See Figure 10.16. Use the 150 mm line.
•Lubricate pipe or flue with water and slide the flashing down. It may be necessary to trim the top shingles around the base of the rubber boot to ensure a good fit.
•Draw around flashing, remove.
•Apply silicone sealant to roof inside the lines (Figure 10.17)
•Lubricate pipe or flue with water and slide flashing down. Seat firmly in sealant. Nail roof flashing to the roof.
Figure 10.17 Apply Sealant
APPLY SEALANT
TOP & PARTIAL SIDES
Figure 10.18 Slide Flashing Down, Secure & Apply Sealant
•Apply silicone sealant on the top outside of the base plate on the sides and on top edge. See Figure 10.18. Install shingles, Apply sealant at the top edge of the rubber boot. See Figure 10.19.
•We recommend that you top coat with conventional acrylic house paint to improve the appearance of your galvanized base flashing.
SILICONE SEALANT (TOP OF BOOT)
SHINGLES TRIMMED
FLASHING OVER | SHINGLES OVER | |
SHINGLES | ||
FLASHING | ||
|
Figure 10.19 Installation Complete
Figure 10.16 Trim Rubber Boot
40 | Heat & Glo • SLR • |