INSTALLATION
LOG SET INSTALLATION
WARNING: Dangerous operating conditions may occur if these logs are not positioned in their correct certified locations. Read the fol- lowing instructions carefully and refer to the attached diagram.
1)Remove the logs from the box and carefully unwrap them. The logs are fragile, handle with care. Do not force into position.
2)Place the rear log on the rear log support in the back of the unit with the flat side of the log facing the back of the unit. Carefully push the log down onto the pins.
3)Sprinkle the vermiculite on the sides and front of the fireplace bottom being careful not to get any into the air shutter or the burner ports (burner ports are the little holes in the top of the burner). The vermicu- lite is used to cover the sheet metal and hardware on the firebox floor and burner assembly.
4)Pull off ember size pieces of rockwool and gently place them around the whole burn- er. Do not compress the rockwool, leave it loose for the most realistic looking embers. Refer to the diagrams below for correct placement of rockwool on the Natural Gas and Propane units.
5)Place the front logs in the unit, aligning the holes on the underside of the logs with the log support pins in the front of the unit. Carefully push the logs down onto the pins. (Hint: Install the front right side first.)
6)Place a few embers under the front logs and a few under the front part of the burner assembly to make it look like fallen embers.
7)Test for pilot ignition.
8)Install the door and louvers.
NATURAL
GAS
Burner tray without front logs in place
PROPANE
IMPORTANT
For Propane Units - only place rockwool on the
rear burner tray behind the burner tube.
All 3 logs in place
24 | Regency |