INSTALLATION
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the flush front. The standard flush door and glass must remain on the unit.
1)Unhook the 2 spring loaded hooks from the bottom of the flush door.
2)Hook the top of the bay door over the flush door flange and swing the bottom against the bottom flange of the flush door.
4)Reconnect the 2 spring hooks securing the flush door.
5)Slide the valve extension knobs onto the valve knobs.
Note: If any maintenance etc. must be done in the firebox, first remove the Bay louvers and door.
Optional Bay Trim
BAY LOUVERS
1)Install top louver by sliding the two bracket clips into the brackets located on top of the bay door. See below. The fitted louver leaves a small gap between faceplate bottom and louver top.
Attach 4 supplied magnets each to the back of the top and bottom trim pieces, and attach trim to the top and bottom of Bay door. See diagrams 3 and 4.
Note: Top and bottom louvers and brackets are different.
2)Install bottom louver by sliding the two bracket clips into the brackets located un- derneath the bay door. Install bottom louver by sliding the two bracket clips into the brackets located underneath the bay door and secure with 1 screw on each end.
Diagram 3
3) Secure to the flush door bottom bracket with
2 screws provided.
Diagram 4
26 | Regency |