INSTALLATION
STANDARD
FLUSH DOOR
The standard flush door comes with a black frame. To install the frame, simply hook the top door flange onto the top of the unit and swing the door towards the unit, diagram 1.
FLUSH LOUVERS
1)Install the top louver by sliding the two bracket clips into the brackets located un- derneath the top of the firebox. Diagram 1.
2)Attach the 2 bottom louver hinges to the bottom flange on the firebox using 2 screws per hinge. Diagram 1.
DOUBLE SCREEN
DOOR
1)Pull out the top louver.
2)Center the screen door and hook over the flush door.
Diagram 1
Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Diagram 2.
Diagram 2
Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd and 3rd spring. See diagram 3.
Diagram 3
NOTE: Springs must always be OVER
not under the gas line.
To remove the flush door, reverse the above steps.
Diagram 1
Note: Top and bottom louvers are different.
3)Attach the bottom louver to the 2 hinges using 2 screws per hinge. Diagram 2.
Diagram 2
3)Open the screen door(s) and secure the screen door to the flush door front with 2 clips on the bottom left and right side.
Clip locations
Clip installed on right side.
Regency | 25 |