MAINTENANCE
GOLD-PLATED
LOUVERS
The 24 carat
DO NOT use abrasive materials or chemical cleaners, as they may harm the finish and void the warranty.
Clean any fingerprints off before turning the unit on.
GLASS
REPLACEMENT
Your P42 stove is supplied with high tempera- ture, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break the glass, purchase your replacement glass from an au- thorized Regency dealer only, and follow the
Caution: Wear gloves when remov- ing damaged or broken glass.
Bay Glass Replacement
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Remove the nuts holding the glass clips in place and remove.
3)Replace the glass. The glass must have gasketing around it.
LOG REPLACEMENT
The unit should never be used with broken logs. Turn off the gas valve and allow the unit to cool before opening door and carefully remove the logs. (The pilot light generates enough heat to burn someone.) If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagrams under Log Installation.
Note: Improper positioning of logs may create carbon
THERMOPILE/
THERMOCOUPLE
1)Remove the top louver and open the bottom louvers.
2)Open and remove door.
3)Remove front logs.
4)Remove burner.
5)Loosen the thermocouple or thermopile with a 7/16" wrench.
6)Disconnect thermocouple by loosening nut from the valve with a 9mm wrench. Discon- nect thermopile by loosening 2 screws marked TP on the valve.
7)Peel the silicone from the hole in the base of the unit and drop the thermocouple or thermopile down from the bracket and pull it out of the unit.
8)Reinstall the new ones in reverse order making sure to seal the hole in the firebox with silicone in order to maintain the seal integrity of the firebox.
DOOR GLASS
Your Regency stove is supplied with high temperature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. If your glass requires cleaning, we recommend using an approved glass cleaner available at all authorized deal- ers. Do not use abrasive materials. Do not clean the glass when hot.
In the event that you break your glass by impact, purchase your replacement from an authorized Regency dealer only, and follow our
WARNING
The use of substitute glass will void all product warranties.
Do not operate the appliance
with the glass panel(s) re- moved, cracked or broken. Replacement of the glass panel(s) should be done by an authorized service person.
Flush Glass Replacement
Remove the flush door front (as per instructions on page 25). Remove the 4 glass clips from each corner. Slide in the new re- placement glass. Push the 4 glass clips back onto the frame.
The glass must have gasketing around it.
4)Reverse the previous steps, replace the glass clips and fasten with the nuts but do not over tighten, as this can break the glass.
5)Replace door on the stove and check the seal.
WARNING: Do not operate the appliance with the glass panels removed, cracked or broken. Re- placement of the glass panels should be done by a licensed or qualified service person.
34 | Regency |