Regency P33-NG3, P33-LP3 Full Screen Front, Cut-Out Oblong Hole Top Flange Bottom, Cut-Outs

INSTALLATION

FULL SCREEN FRONT

1)Before beginning the installation, remove the Glass Door from the unit. Refer to the manual for instructions.

2)Slide the Bottom Face Plate Bracket into the bottom of the unit, secure it into the pins located on the inside of the fi re box. Once the bracket is in place, tighten the screws into the hinges on the left and right sides.

BottomFaceplate

Bracket

Pin location

4)a) Before attaching the Full Screen Door Frame to the unit, loosen the left and right side #8 Self Tapping Philips screws located on the inside top of the outer frame of the appliance. Also remove the center screw.

b)Slide the cut-outs in the Top and Bottom Flange of the Full Screen Door Frame under the screw heads which were loosened in step 4a). Once the Frame is in place, tighten the screws to secure. Also re-secure the top center screw through the oblong hole.

Full Screen Door

Frame

Faceplate

Mounting

BracketScrew

3)Before attaching the Full Screen Door Frame, remove the Screen Doors from the Full Screen Door Frame by fully opening the doors and lifting up off of the hinges. See important note in step 10.

Cut-Out

Oblong Hole

Cut-Out

Top

Flange

Bottom

Backside of FullFlange

Screen Door

Frame Shown

Cut-Outs

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace