Installing the Optional FAN, Shut the power off

INSTALLATION

INSTALLING THE OPTIONAL FAN

120 Volt AC power is needed for the fan switch and blower. The fan can be hard wired if desired. The receptacle box should be installed on the left hand side of the unit by a qualiﬁ ed electri- cian. The neutral (wider) slot of the polarized receptacle should be at the top.

Unit must be grounded at all times. Do not cut the ground terminal off under any circumstances.

11)Attach the two control boxes to the bottom louver and tighten the 2 screws on the left side and 1 screw on the right side.

1) Shut the power off.

2) Remove the standard ﬂ ush door and the optional bay door, if installed. Open the bottom louver door.

Diagram 2

Secure left side with 2 screws.

3) Loosen the 2 screws holding the Burner ON/OFF switch and bracket to the bottom louver and lift the assembly out.

Diagram 3: Use the clip & hook on the side of

the control boxes to join them together.

8)Secure the two boxes together with one screw.

4)Turn the fan base on its side (with the base facing towards you) and then slide the fan in towards the rear of the unit. Turn the fan upright and slip it over the two mounting studs.Takecarenottodamagetheinsulation on the fan base. Ensure that the fan blades do not rub against the valve tubing. Diagram 1.

5)Connect fan ground cable to ground lug. Refer to wiring diagram.

6)Slide the thermodisc/cover assembly into the bracket clip on the underside of the ﬁ rebox. Check that no wire will touch the hot surfaces. Diagram 2.

7)Attach the Fan control box to the Burner ON/OFF control box. Diagram 3.

Secure the 2 boxes together

with one screw.

9)Position the control box assembly on the bottom louver and mark the position of the slot on the right side bracket.

Hold control box assembly in place and mark the position of the right side slot

10)Remove the control box assembly and push the hold-down clip onto the louver. Bend the tab until it is at 90o to the louver.

Push hold-down clip onto inside louver and press tab until it is at 90o to louver.

Secure right side with one screw.

12)Secure the fan wires and power cord by attaching one of the adhesive backed wire holder clips (Part #910-199) onto the stove base. Use the second clip to bundle up the wires approximately 4" from the control box. Ensure that there is no interference with the wires when the louver is closed and that no wire will touch the hot metal surfaces or sharp edges.

13)Plug the fan power cord into the rear end of the receptacle box to provide the maximum clearance from the louvers.

TO REMOVE THE FAN

1)Shut the power off.

2)Reverse the above instructions.

Note: The bearings are lubricated for life. Do not lubricate them. Make sure you vacuum the fan area on a regular basis.

IMPORTANT:

These fans collect a lot of dust from within your home. Ensure you maintain these fan motors on a regular basis by vacuuming out the fan blades and housing using a soft brush nozzle.

Diagram 1

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace