Regency P33-NG3, P33-LP3 Flush Louvers, Double Screen Door, Optional BAY Door, Optional Bay Trim

Page 29

INSTALLATION

FLUSH LOUVERS

1)Install the top louver by sliding the two bracket clips into the brackets located un- derneath the top of the ﬁ rebox.

2)Install the bottom louver by folding the louver down and then sliding the Bottom Louver bracket down onto the 2 pins on the base of the unit (dia. 1). Secure with 1 screw as per dia. 2.

DOUBLE SCREEN

DOOR

1)Pull out the top louver.

2)Center the screen door and hook over the ﬂ ush door.

Diagram 1

Diagram 2

3) Open the screen door(s) and secure the screen door to the ﬂ ush door front with 2 clips on the bottom left and right side.

Note: Top and bottom louvers are different.

3)Open the bottom louver. Pull the Burner ON/OFF control box from inside the bottom of the ﬁ replace and position the slots in the bracket over the 2 screws on the left side of the bottom louver. Push down to lock into place. Tighten the screws.

	Note: If any maintenance etc. must be done
	in the ﬁrebox, ﬁrst remove the Bay
	louvers and door.
	Optional Bay Trim
Clip locations	Attach 4 supplied magnets each to the back of
	the top and bottom trim pieces, and attach trim
	to the top and bottom of Bay door.

Clip installed on right side.

OPTIONAL BAY DOOR

The Bay louvers MUST be used

with the Bay glass option.

Screws on lou-	Burner ON/OFF
ver bracket	control box

Burner ON/OFF control box attached to bot-

tom ﬂ ush louver.

The optional Bay door is an overlay on the ﬂush front. The standard ﬂ ush door and glass must remain on the unit.

1)Hook the top of the bay door over the ﬂ ush door ﬂ ange and swing the bottom against the bottom ﬂ ange of the ﬂ ush door.

2)Secure to the ﬂ ush door bottom bracket with 2 screws provided.

3)Slide the valve extension knobs onto the valve knobs.

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace

Image 29

Contents P33-3 Zero Clearance To the New Owner Information for MOBILE/MANUFACTURED Homes After First SaleTable of Contents Safety Label General Safety Information InstallationSave These Instructions Before YOU StartUnit Dimensions Installation ChecklistLocating Your GAS Stove Duct System OptionMantel LEG Clearances Clearancescombustible MantelsClearances are not adhered to Fire hazard is an extreme risk if theseRear Termination Framing and FinishingSimpson Dura-Vent Minimum Clearances Vertical Termination or Vertical Rise with HorizontalTop Standoff Assembly Unit Assembly Prior to InstallationVenting Introduction Top Facing Support Side Nailing StripsVent terminal Air supply outlet VentRegency Direct Vent System Flex Horizontal Terminations only For Regency Direct Vent System Flex Installation ProceduresRigid Pipe Venting Systems Flat Wall InstallationMax. Wall Vent Length Thickness inches Required inchesDirect VentGS R Direct-Temp TM Rigid Pipe Venting Components ListDescription Simpson Dura-Vent Selkirk Propane & Natural Gas Rigid Pipe Venting Arrangements Vertical TerminationsInstallation Regency Direct Vent System Flex Rigid Pipe Venting Arrangements Horizontal TerminationsOption + H1 Horizontal Venting with Two 2 90o ElbowsHorizontal Venting with Three 3 90o Elbows Option + V1 H + H1 Vertical Venting with Two 2 90o ElbowsOption + V1 With these options, max. totalVertical Venting with Three 3 90o Elbows Required Parts Vertical Termination With CO-LINEAR Flex SystemDescription Alternate Approved CapsInstallation Snorkel Terminations Horizontal InstallationsBelow Grade Snorkel Installation Vertical Termination GAS Line InstallationGAS Pipe Pressure Testing Pilot AdjustmentHigh Elevation T. Valve DescriptionConversion Kit Contains Optional Brick Panels LOG SET InstallationNotch BracketBracketOptional Flush Trim Standard Flush DoorCutout 5th Grate TabDouble Screen Door Flush LouversOptional BAY Door Bay louvers Must be used With the Bay glass optionFlush Louver Top Heat Shield BAY LouversBay Louver Top Heat Shield Burner ON/OFF Control boxCut-Outs Full Screen FrontCut-Out Oblong Hole Top Flange Bottom Top Grill Hinge Location Bottom GrillThermostat Wire Table Optional Wall SwitchDo not cut the ground terminal off under any circumstances Wiring DiagramShut the power off Installing the Optional FANDiagram Secure left side with 2 screws Secure the 2 boxes together With one screwCopy of the Lighting Plate Instructions Operating InstructionsShutdown Procedure Lighting ProcedureAeration Adjustment Operating InstructionsMaintenance Instructions MaintenanceLOG Replacement Normal Operating Sounds GAS AppliancesThermopile Thermocouple Flush Glass ReplacementGlass Gasket Door GlassDiagram 3 Lift out Valve Tray Assembly Installing ValveRemoving Valve Shut off the gas supplyDescription Parts ListParts List Part Description Burner & Log AssemblyFlush Front & Louvers Bay Front & Louvers Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Conditions WarrantyInstaller Please complete the following information