|
|
3 | Counterbalance Cables |
| |
|
|
Tools Needed: | IMPORTANT: Right and left hand is |
None | always determined from inside the |
| garage looking out. |
| NOTE: For door section identification see |
| page 4. |
| Uncoil the counterbalance cables and |
| slip the loop at the ends of the cables |
| over each milford pin on the bottom |
| section. |
| Insert a roller into bottom bracket of the |
| bottom section and insert another roller |
| at #1 end hinge at the top of the bottom |
| section. Repeat for other side. |
| NOTE: Verify astragal (bottom seal) |
| is aligned with door section. If there |
| is more than 1/2” excess astragal on |
| either side, trim astragal even with door |
| section. |
|
|
Counterbalance
cable
#1 end
hinge (hinge
tube)
BOTTOM SECTION
BOTTOM
SECTION
rollers
MILFORD PIN | bottom bracket |
BOTTOM
SECTION
astragal
INSTALLATION
4 | Bottom Section | ||
| door opening | ||
Tools Needed: | Before installing the bottom section, | ||
Level | the weather seal (may not be included) | ||
must be installed (see Preparing the | |||
| |||
| Opening on page 10) |
Center the bottom section in the door opening. Level section using wooden shims (if necessary) under the bottom section.
weather seal
Level
BOTTOM
SECTION
wooden shims (if necessary)
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts 13 You May Need. You can reach us Toll Free at