Wayne-Dalton 9800 installation instructions Door Section Identification

	Door Section Identification
Tools Needed:	NOTE: This provides an alternative method
	for identifying your door sections/stacking
	position.
	Hinges are always pre-attached at the top	#3	Top Section
	of each section (except top section) and
	the hinges are stamped for identification,
	#1, #2, #3, and #4 (#4 only on five		warning label
	section doors). See view below. The
	stamp identifies the stacking sequence		(May be on right or left hand side)
	of the section. The sequence is always
	determined by #1 being the bottom		Intermediate Section
	section to #3 or #4 being the highest	#2
	intermediate section. See views to the
	right. If the stamp on the end hinge is
	illegible, refer to the section side view
	illustration to the right.
	The section side view illustration shows
	the end hinge profile of all the sections,		Lock Section
	and can also be used in conjunction with	#1
	identifying each sections.
	The bottom section can be identified		Bottom Bracket
	by #1 end hinges, the factory attached		warning Labels
	bottom astragal and the bottom bracket
	warning labels on each end stile.
	The lock section can be identified by a		Bottom Section
	#2 end hinge.	astragal
	The intermediate section can be		SECTION side view
	identified by #3 end hinges. The section
	will have a warning label attached to		1 3/8”	1 1/8”	7/8”
	either the right or left hand end stile.
	NOTE: #4 End hinges are used on the
	fourth section of five section doors.		u-bar
	The top section can be identified with		#3 end	#2 end	#1 end
	no pre-installed end or center hinges and		hinge	hinge	hinge
	U-bar attached to the top section.

Top INT. LOCK BOT.

BOTTOM

BRACKET

typical hinge stamping location

ASTRAGAL

4Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts

You May Need. You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com