Wayne-Dalton 9800 installation instructions Trolley Operator, Header Door ARM to Operator Bracket

	Trolley Operator
Tools Needed:	WARNING

OPERATOR MUST BE TESTED

AT TIME OF INSTALLATION AND

MONTHLY THEREAFTER TO

ENSURE THAT DOOR REVERSES

ON CONTACT WITH 2 X 4 BOARD

LAID FLAT UNDER THE DOOR.

FAILURE TO ADJUST OPERATOR,

IF NECESSARY, CAN RESULT IN

SEVERE OR FATAL INJURY. IF YOUR

OPERATOR IS EQUIPPED WITH A

PHOTOELECTRIC EYE SYSTEM,

THEN THIS MUST BE TESTED

AT THE SAME TIME TO ENSURE

THAT DOOR DOES NOT CLOSE

AND A CLOSING DOOR OPENS IF

PHOTOELECTRIC EYE SYSTEM IS

OBSTRUCTED. FAILURE TO MAKE

ADJUSTMENTS, IF NECESSARY,

CAN RESULT IN SEVERE OR FATAL

INJURY.

1.Install operator rail 1/2” to 1-1/2” (13 - 38 mm) above high arc of top section of the door.

2.Mount operator to ceiling so that 1” to 1-1/2” (25 - 38 mm) clearance is maintained between trolley rail and top section when door is fully open (trolley rail will slope down towards rear).

3.Attach door arm to operator bracket installed in Step 8.

4.Attach operator rail to suitable mounting surface, 2 x 6 lumber minimum.

5.Attach operator to ceiling using perforated angle.

IMPORTANT: Angles must be securely attached to sound framing member(s).

SUITABLE MOUNTING	OPERATOR RAIL
SURFACE 2 X 6
LUMBER MINIMUM

HEADER

DOOR ARM TO OPERATOR BRACKET

perforated

OPERATORangle rail

OPERATOR

FRAMING MEMBERS

PERFORATED ANGLE

28Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts

You May Need. You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com