Wayne-Dalton 3322B-Z, 3324B, 3320B Entrapment, Apply entrapment warning label in a, Not adhere

Page 14

Deluxe Multi-Function Wireless

Wall Station Installation Continued

(If Included)

Remove the battery cover (right-hand side of wall station) by disengaging the battery cover’s lower clip. Install two AAA batteries into the wall station observing the polarity, (+) and (-), of both batteries. After about three seconds, the red LED will begin to blink every three seconds. Re-install the battery cover by first inserting its top into the wall station then inserting and securing its bottom.

NOTE: To slow blink rate or turn off, refer to wall station operation page 28 “Back Lit LED Light”.

Up/Down

LED

Wall

Station

per

O

at

o

e

T

D

Presso

o

Here r

(2)AAA Batteries

Battery Cover

Lower

Clip

10

Entrapment

 

 

Warning Label

 

 

Tools Needed:

Apply entrapment warning label in a

 

convenient location next to the wall station.

None

Use mechanical fasteners if adhesive will

 

not adhere.

 

 

Wall Station

Service

Entrance

Door

Entrapment

Warning Label

8Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Image 14
Contents Rev.3 7/19/2007 Important NoticeGarage Doors & Openers Package Contents Page Door Test One Pre-InstallationDisconnect from power source and proceed to assembly Door Test TwoHomelink Compatibility Rolling Code Technology System FeaturesTools Needed Table of Contents Definition of key words used in this manualInstallation Attaching Opener to RailReinforce the Header Wall Positioning and Installing Front Wall BracketService Person Attach Unit to Front Wall Bracket Positioning MotorEnd of Opener AT Least 3 Feet LongProper Installation Mounting Opener EndManufacturer for Proper Installing LightMounting Door Bracket Reinforcing of Your DoorWall Station Near or Next to Wired Wall Station Installation If IncludedDoor can be Seen When Garage DoorWall Station OUT of the Reach Wall Station Installation If IncludedWall Station Near or Next to Garage Door Children and in a Location WhereNot adhere EntrapmentApply entrapment warning label in a Wired Infrared Safety Sensor Installation Connecting Wired Infrared Safety Installation of Wiring for WiredInfrared Safety Sensor Sensor to OpenerTo Latch Assembly Connecting OpenerConnecting Trolley Cord in AnywayBe Closed by Continuously Alignment of Wired InfraredSafety Sensors Fully Closed PositionTo Avoid Possible Injury or Setting Trolley Close PositionARM Connecting Door Arm to Door Setting Door Close Travel Setting Door Opening TravelStop Bolt Trolley Opener Result from Operating the DOOR/OPENER Contact Obstruction TestFatal Injury MAY Result Possible Personal Injury Programming Wireless KeylessEntry If Included To Prevent Door Damage orSurface inside garage Important Install ALL WallWood framing using the two screws MaterialsImportant Check Your Local Power ConnectionTo Avoid Electrical Shock Instructions IllustratedMounting Door Bracket To Series Door Optional InstallationsTools Needed Power Drill Socket Driver 14 x 5/8 self tapping screws as shown in FIGWith Step Must be Adjusted ProperlyShown in FIG 1/4 14 x 5/8 self-tapping screwsLOW Headroom Radius Being UsedTrack Standard LiftConnecting Door Arm DIM Type of ARMDistance forward To Door , on Trolley settingsDetermine the WAYNE-DALTON Track Radius Being Used Have to cut straight arm to accomplishLOW Headroom Trolley Positioning Chart for Door activation OperationRead and Follow ALL Instructions Operating the Wireless Wall Station Customizing the Settings Opener ControlsTeaching HomeLink to the opener Primary Programming for HomeLink to the ProdriveProgramming/Training HomeLink Unit Alternate Programming for HomeLink to the Prodrive Closing Force Adjustment AdjustmentsAdjustment # 1 Opening and Closing Force Opening Force AdjustmentWall Station Tools Needed NoneTransmitter Twice a Year MaintenanceBattery Replacement for Wall Station Symptom Probable Cause Corrective Action  TroubleshootingMAINTENANCE/ Troubleshooting # Per Unit Parts Breakdown Rail Assembly All ModelsDescription Parts Breakdown Opener Assembly And Accessories All Models Description # Per UnitProdrive Accessories Wireless Keyless EntryPre-drill 5/64 pilot hole Pre-drill 3/32 pilot holeDrill Template Please Do Not Return This Product To The Store Thank you for your purchaseLifetime Limited Warranty Replacement laborPatent Information FCC and IC Statement