IMPORTANT SAFETY INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:
1.READ AND FOLLOW ALL INSTRUCTIONS.
2.Never let children operate or play with the door controls. Keep remote controls away from children.
3.Always keep a moving door in sight and keep people and objects away until it is completely closed. NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR.
4.NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.
5.Test the Door/Opener monthly. The garage door MUST reverse on contact with a
6.When possible, use the Emergency Disconnect only when the door is in the closed position. Be very cautious using the Emergency Disconnect when the door is open. Weak or broken spring(s) may allow the door to fall rapidly, causing a severe or fatal injury.
7.KEEP THE GARAGE DOOR PROPERLY BALANCED. See the owner’s manual included with the door. An improperly balanced door could cause a severe or fatal injury. Have a qualified service person make repairs to the cables, spring assemblies, and other hardware.
8.SAVE THESE INSTRUCTIONS.
Door activation:
Upon activation by either the wall station Up/Down button, transmitter or wireless keyless entry, the door will move in the following manner:
1.If open, the door will close. If closed, the door will open.
2.If closing, the door will stop. Next activation will open.
3.If opening, the door will stop. Next activation will close.
4.If an obstruction is contacted or the safety sensor beam is interrupted while closing, the door will reverse and the light will flash.
5.If an obstruction is encountered while opening, the door will stop and the light will flash. The next activation will close the door.
6.The Infrared Safety Sensor uses an invisible beam which, when broken by an obstruction, causes a closing door to reverse, prevents an open door from closing and causes the light to flash.
WARNING
ALWAYS KEEP MOVING DOOR IN SIGHT AND KEEP PEOPLE AND OBJECTS AWAY UNTIL IT IS COMPLETELY CLOSED. TO PREVENT A SEVERE OR FATAL INJURY, AVOID STANDING IN A OPEN DOOR WAY OR WALKING THROUGH THE DOORWAY WHILE THE DOOR IS MOVING.
WARNING
NEVER LET CHILDREN OPERATE DOOR OR PLAY WITH THE DOOR CONTROLS. KEEP REMOTE CONTROLS AWAY FROM CHILDREN. FATAL INJURY COULD RESULT SHOULD A CHILD BECOME TRAPPED BETWEEN THE DOOR AND FLOOR.
WARNING
KEEP THE GARAGE DOOR PROPERLY BALANCED. AN IMPROPERLY BALANCED DOOR COULD CAUSE SEVERE OR FATAL INJURY. HAVE A QUALIFIED SERVICE PERSON MAKE ADJUSTMENTS/REPAIRS TO CABLES, SPRING ASSEMBLIES, AND OTHER HARDWARE.
Emergency Disconnect:
WARNING
THE DOOR SHOULD BE FULLY CLOSED WHEN ACTIVATING THE EMERGENCY RELEASE DISCONNECT. WEAK OR BROKEN SPRINGS COULD ALLOW AN OPEN DOOR TO FALL RAPIDLY POSSIBLY CAUSING SEVERE OR FATAL INJURY.
The opener is equipped with an emergency release recessed trolley type disconnect system, enabling manual operation of the garage door during power failure. The trolley is disconnected from the chain by pulling down on the red release knob, allowing the garage door to be operated manually. Do not use the manual release knob to pull the door open or closed. The trolley will automatically reconnect when power is restored and door is activated. If emergency release is used, close door before operating opener.
NOTE: Outside keylock emergency releases are an available accessory and are recommended for garages without a service entrance.
HOW THE LIGHT WORKS AND WHAT IT MEANS WHEN IT FLASHES:
1.Overhead light automatically turns on when opener is activated and remains on for 4 minutes for convenience and safety.
2.The light will flash if opener senses an obstruction in the up or down direction, to warn you of a problem. It will continue flashing for 1 minute, and then shut off.
If the light begins to flash and the door moves a short distance and then reverses from a wall station button, transmitter or keyless entry, the external safety sensor device is activated or defective. To temporarily override safety sensor device and close door, activate wall station up/down button, keeping button depressed; opener will begin in down direction. The button must remain depressed until cycle is completed. If the button is released before cycle is completed, the door will reverse and come to full up position. Problems in the safety system should be corrected by a qualified service person.
NOTE: A fully open door with a blinking light indicates an obstruction or problems with external safety sensors during close travel. See trouble shooting section on page 35.
OPERATION
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need 27 You can reach us Toll Free at