Wayne-Dalton 3322B-Z, 3324B, 3320B Maintenance, Twice a Year, Battery Replacement for Wall Station

Page 40

I

Maintenance

Monthly Maintenance:

1.Lubricate hinges and rollers of garage door.

2.Inspect the door for loose fasteners, worn or frayed counterbalance cables and the presences of legible safety labels/ tags. Have repairs made by a qualified service person. Contact customer assistance for free replacement safety labels/ tags.

3.With door fully closed, pull down on the emergency disconnect to manually operate the door. If the door feels unbalanced or binds, have a qualified service person make necessary adjustments or repairs to the door.

4.Perform the contact/obstruction tests. See Steps 21 and 22 for the contact/obstruction test instructions. If door/opener fails contact/ obstruction test reset the door close limits according to the instructions in Step 19, adjusting until door reverse on contact with a 2 x 4 board laid flat on the garage floor. If opener still fails, have a qualified service person make adjustments/repairs or this could result in severe or fatal injury.

5.Failure of door/opener to respond to transmitter, multi-function wall station or wireless keyless entry may be due to a weak or dead battery. Replace the battery.

Twice a Year:

Check chain tension. If chain rests on bottom of rail, adjust tension by turning the two chain adjusting nuts at the end of the rails (opposite the opener end) clockwise. Make sure to adjust both nuts equal amounts and until chain is approximately 1/2” above the bottom of rails when measured in the middle of the rail length.

Battery Replacement for Wall Station:

Remove the battery cover completely (right-hand side of wall station) by disengaging the battery cover’s lower clip; remove the remove the old batteries. Install two AAA batteries into the wall station observing the polarity, (+) and (-), of both batteries. After a few seconds, the red LED will begin to blink every three seconds. If it is desired to slow the LED blink rate refer to the wall station operation section on page 28 “Backlit LED Lights”. Re-install the battery cover by first inserting its top into the wall station then inserting and securing its bottom.

Note: Use only two AAA batteries.

Note: Dispose of dead batteries properly.

Battery Replacement for Transmitter:

Insert a coin in the coin slot of the transmitter and twist coin to access the dead battery. Replace the battery, being careful to match the positive (+) symbols on the circuit boards with the battery; snap case back together.

Note: Transmitters use (1) CR2016 or equivalent battery.

Note: Dispose of dead battery properly.

Battery Replacement for Wireless Keyless Entry:

To change battery, snap open case with a coin and remove old battery. Replace the battery, being careful to match the positive

(+)symbols on the circuit boards with the battery; snap case back together.

Note: Keyless entries use (1) CR2032 or equivalent battery.

Note: Dispose of dead battery properly.

34Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Garage Doors & Openers Important NoticeRev.3 7/19/2007 Package Contents Page Pre-Installation Disconnect from power source and proceed to assemblyDoor Test One Door Test TwoTools Needed System FeaturesHomelink Compatibility Rolling Code Technology Table of Contents Definition of key words used in this manualInstallation Attaching Opener to RailService Person Positioning and Installing Front Wall BracketReinforce the Header Wall Positioning Motor End of OpenerAttach Unit to Front Wall Bracket AT Least 3 Feet LongProper Installation Mounting Opener EndInstalling Light Mounting Door BracketManufacturer for Proper Reinforcing of Your DoorWired Wall Station Installation If Included Door can be Seen WhenWall Station Near or Next to Garage DoorWall Station Installation If Included Wall Station Near or Next to Garage DoorWall Station OUT of the Reach Children and in a Location WhereApply entrapment warning label in a EntrapmentNot adhere Wired Infrared Safety Sensor Installation Installation of Wiring for Wired Infrared Safety SensorConnecting Wired Infrared Safety Sensor to OpenerConnecting Opener Connecting TrolleyTo Latch Assembly Cord in AnywayAlignment of Wired Infrared Safety SensorsBe Closed by Continuously Fully Closed PositionARM Setting Trolley Close PositionTo Avoid Possible Injury or Connecting Door Arm to Door Setting Door Close Travel Setting Door Opening TravelStop Bolt Trolley Opener Fatal Injury MAY Result Contact Obstruction TestResult from Operating the DOOR/OPENER Programming Wireless Keyless Entry If IncludedPossible Personal Injury To Prevent Door Damage orImportant Install ALL Wall Wood framing using the two screwsSurface inside garage MaterialsPower Connection To Avoid Electrical ShockImportant Check Your Local Instructions IllustratedOptional Installations Tools Needed Power Drill Socket DriverMounting Door Bracket To Series Door 14 x 5/8 self tapping screws as shown in FIGMust be Adjusted Properly Shown in FIGWith Step 1/4 14 x 5/8 self-tapping screwsRadius Being Used TrackLOW Headroom Standard LiftConnecting Door Arm DIM Type of ARMTrolley settings Determine the WAYNE-DALTON Track Radius Being UsedDistance forward To Door , on Have to cut straight arm to accomplishLOW Headroom Trolley Positioning Chart for Read and Follow ALL Instructions OperationDoor activation Operating the Wireless Wall Station Customizing the Settings Opener ControlsProgramming/Training HomeLink Unit Primary Programming for HomeLink to the ProdriveTeaching HomeLink to the opener Alternate Programming for HomeLink to the Prodrive Adjustments Adjustment # 1 Opening and Closing ForceClosing Force Adjustment Opening Force AdjustmentTransmitter Tools Needed NoneWall Station Battery Replacement for Wall Station MaintenanceTwice a Year MAINTENANCE/ Troubleshooting  TroubleshootingSymptom Probable Cause Corrective Action Description Parts Breakdown Rail Assembly All Models# Per Unit Parts Breakdown Opener Assembly And Accessories All Models Description # Per UnitProdrive Accessories Wireless Keyless EntryDrill Template Pre-drill 3/32 pilot holePre-drill 5/64 pilot hole Please Do Not Return This Product To The Store Thank you for your purchaseLifetime Limited Warranty Replacement laborPatent Information FCC and IC Statement
Top Page Image Contents