Wayne-Dalton 3222C-Z, 3324B, 3322B-Z Positioning and Installing Front Wall Bracket, Service Person

2Positioning and Installing

Front Wall Bracket

Tools Needed:	NOTE: It is recommended that the door
	opener be installed 7 feet or more above the
Carpenter’s Level	garage floor.
7/16” Socket	REINFORCE THE HEADER WALL
Driver	Reinforce the header wall (wall above door
	opening) as required, to ensure rigid
Power Drill	mounting of the front wall bracket.
Tape Measure	WARNING
1/8” Drill Bit	DO NOT ATTEMPT TO LOOSEN OR
	REMOVE ANY PORTION OF DOOR SPRING
	SYSTEM IN ORDER TO REINFORCE
	HEADER WALL OR TO MOUNT WALL
	BRACKET. SPRING SYSTEM IS UNDER
	EXTREME TENSION AND CAN CAUSE
	SEVERE OR FATAL INJURY. SUCH WORK
	SHOULD BE DONE BY A QUALIFIED
	SERVICE PERSON.
	Locate the vertical center line of the garage
	door and mark it on the header above the
	door.
	Raise the door slightly until the top section
	reaches the highest point of travel (High Arc
	Point); using a carpenter’s level, transfer
	and mark the highest point of travel onto the
	header wall and close the door.
	Mount the front wall bracket with its lower
	edge approximately 1/2” -1” above the
	mark showing the highest point of travel and
	centered on the vertical center line.
	NOTE: For low headroom torsion
	counterbalance, hold the wall bracket’s
	bottom edge typically at 1/2” - 1” (room
	permitting) above the torsion spring center
	bracket and centered on the vertical line, see
	illustration.
	Mark the two mounting holes and pilot drill
	with a 1/8” drill bit. Mount wall bracket using
	the 1/4” x 1-1/2” lag screws supplied to
	ensure rigid mounting.

	Reinforce with 2” x 6” as required to
	insure rigid mounting.
	Vertical Center Line
Header	Carpenter’s Level
	High Arc Point
	Top Section
	Sectional Door
	Curved Track
	1/4” X 1 1/2”
	Lag Screws
1/2” - 1” Above
High Arc Mark
	Front Wall
	Bracket
High Arc	Center of
	Door
Mark
1/2” - 1” Above
Center Bracket	Front Wall
(Room Permitting)
	Bracket
Top Edge Of	Torsion Spring
Center Bracket
Center Bracket	Center Line

2Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com