Genie GCG, H, PCG manual Slip carriage into carriage slot of rail, Attach rail to power head

CAUTION

Make sure that the carriage magnet is in place in the top of the carriage slide.

5.Slip carriage into carriage slot of rail.

•Flip the rail assembly up side down.

•Place emergency release lever in release position (See below).

–Check arrow on the side of carriage points toward door end of rail.

–Slide carriage into rail at power head end (Fig. 1-5).

–Flip rail assembly right-side up.

6.Attach rail to power head.

•Place rail in front of power head with rail strap at opposite end.

•Support door end of rail (rail strap) at about same height as power head.

–Check if magnet is in place (Fig. 1-6 inset). Insert carriage slide into rail (Fig. 1-6). (Carriage slide is long straight piece attached to chain.)

–Pull rail toward you as you feed chain into it. (Fig. 1-6). When the end of the rail is within about 2 chain links of the power head, you can then push it the rest of the way. (It is a snug fit.)

–Securely fasten with 2 bolts (9) and nuts (10) (Fig. 1-7).

[ ]1/4"-20 x 5/8"	[10]
9	1/4"-20

OPEN GREEN PARTS BAG

7.	Attach emergency release cord, knob and tag.
	•	Tie overhand knot in 1 end of cord. Tighten knot.
		(FIG. 1-8 inset A).
		– Slip opposite (no knot) end through knob.
		– Slip through hole in emergency release lever
		(Fig. 1-8).
		– Tie overhand knot in this end also. Tighten knot.
8.	Attach emergency release tag.
	•	Attach to hole in emergency release using metal

Rail is up-side down

FIG. 1-5 Align arrow.

carriage slide

magnet

FIG. 1-6 Slip carriage slide into rail.

FIG. 1-7 Attach rail to power head.

9

twist tie on tag. (Fig. 1-8 inset B).

B

wire

twist

tie

overhand knot

A

Lever in release position. FIG. 1-8 Attach emergency release cord & tag.