Genie PCG, GCG, H manual Operator Assembly

8

1 OPERATOR ASSEMBLY

RAIL ASSEMBLY: Use a clean, flat surface.

CAUTION

Drive chain can slide out of rails. Do not run until operator is fully assembled.

NOTE: For 1-piece rail skip to step 4.

1.Identify the rail sections (Fig. 1-1).

•First rail section (attaches to power head).

–2 holes each end.

–Half-circle notch 1 end.

–Motor end has no notch.

•Middle rail section.

–2 holes & half-circle notch each end.

•End rail section (attaches to door).

–Has 4 holes on door end.

NOTE: Rail assemblies are for 7 foot 6 inch high door. An extension kit for an 8 foot high door is available.

2.Arrange arrows on rail sections.

• Sections have arrows stamped into one side.

– Aim all arrows toward door. (Fig. 1-2)

NOTE: If installing a 3-piece rail assembly with an extension on an 8 foot high door, refer to the instruction sheet included with the optional rail extension at this point.

OPEN BLUE PARTS BAG

3.Attach rail clamps to rail (Fig. 1-3).

•Use pair of clamps at both joints.

–Fasten each pair with 4 bolts (9) and nuts(10).

–Check rail sections aligned and level.

–Securely tighten bolts and nuts.

[9]1/4"-20 x 5/8"	[10]
	1/4"-20

4.Attach rail strap (Fig. 1-4).

•Place rail strap against rail so that projection on strap mates with second hole from end of rail.

–Place 2 bolts (9) through rail strap and rail.

–Ignore fourth hole. (See NOTE)

–Securely tighten bolts and nuts (10).

NOTE: Your rail has 4 holes in the rail strap end. The hole furthest away from the end is for an extension kit if needed.

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

First

Middle

End

FIG. 1-1 Rail sections.

FIG. 1-2 Alignment arrows.

FIG. 1-3 Attach rail clamps.

FIG. 1-4 Attach rail strap.