Care and Cleaning
WARNING
Injury Hazard
Unplug mixer before touching beaters.
Failure to do so can result in broken bones, cuts or bruises.
Bowl, white flat beater and white Dough Hook may be washed in an automatic dishwasher. Or, clean them thoroughly
in hot sudsy water and rinse completely before drying. Wire Whip, burnished Dough Hook and burnished flat beater should be hand washed and dried immediately. Do not wash Wire Whip, burnished Dough Hook and burnished flat beater in a dishwasher. Do not store beaters on shaft.
NOTE: Always be sure to unplug mixer before cleaning. Wipe mixer with a soft, damp cloth. Do not use household/ commercial cleaners. Do not immerse in water. Wipe off beater shaft frequently, removing any residue that may accumulate.
Beater To Bowl Clearance
Your mixer is adjusted at the factory so that the flat beater just clears the bottom of the bowl. If for any reason, the flat beater hits the bottom of the bowl or is too far away from the bowl, clearance can be corrected as follows:
|
|
• Unplug mixer. |
|
• Place |
|
• Turn screw (A) SLIGHTLY |
|
counterclockwise (left) to raise flat |
|
beater and clockwise (right) to lower |
|
flat beater. |
|
• Make adjustments with flat beater, so it | A |
just clears surface of bowl. |
|
Note: When properly adjusted, the flat |
|
beater will not strike on bottom or side of |
|
bowl. If beater or Wire Whip is adjusted |
|
too close so that it strikes bottom of |
|
bowl, coating may wear off beater or |
|
wires may wear through on Wire Whip. |
|
14