1.Position the overlay panel ¹⁄₂" (1.27 cm) higher than the door. Be sure to position the overlay hooks to the pilot holes.
2.Insert the overlay hooks into the top of the holes in the door. Push against the overlay panel to force the overlay hooks deeper into the door. Pull the overlay panel straight down to secure the overlay hooks to the door.
3.Using a Phillips screwdriver, attach the overlay plates to the bottom of the overlay panel and door as shown.
REFRIGERATOR
DRAWERS USE
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
AB C D
A. Overlay panel
B.Door
C.Overlay plates (2)
D.
Complete Installation
1.Remove all boxes, parts packages and packing materials from the interior of the refrigerator drawers.
2.Remove the film.
3.Clean the refrigerator drawers before use.
4.The controls are preset at the factory to the recommended settings. Be sure that the compressor is operating properly and that all the lights are working.
5.If construction will continue after the refrigerator drawers have been installed, turn the power Off for both Drawers.
To get the most efficient use from your new refrigerator drawers, read the “Refrigerator Drawers Use” section.
Normal Sounds
Your new refrigerator drawers may make sounds that your old refrigerator drawers didn’t. Because the sounds are new to you, you might be concerned about them. Most of the new sounds are normal. Hard surfaces, such as the floor, walls, and cabinets, can make the sounds seem louder. The following describes the kinds of sounds and what may be making them.
■Your refrigerator drawers are designed to run more efficiently to keep your food items at the desired temperatures and to minimize energy usage. The high efficiency compressor and fans may cause your refrigerator drawers to run longer than your old ones. You may also hear a pulsating or
■You may hear the evaporator fan motor circulating air through the refrigerator drawers. The fan speed may increase as you open the drawers or add warm food.
■As each cycle ends, you may hear a gurgling sound due to the refrigerant flowing through the sealed system tubing.
■Contraction and expansion of the inside walls may cause a popping noise.
■You may hear air being forced over the condenser by the condenser fan.
■You may hear water running into the drain pan during the Off cycle.
10