INSTALLATION REQUIREMENTS
Tools and Parts
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
■ | Cordless drill | ■ | Tape measure |
■ | ¹⁄₈" Drill bit | ■ | Level |
|
| ■ | Phillips screwdriver |
Additional Tools Needed (Style 2 - Overlay only):
■ Scissors | ■ Scribe |
■Pencil
PARTS NEEDED (Style 2 - Overlay only):
■Custom Overlay Drawer Panels — See “Custom Overlay Drawer Panels.”
■Hardware
PARTS SUPPLIED:
■ Hooks (8) | ■ Screws (16) |
■Overlay plates (4)
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from refrigerator drawer(s).
Failure to do so can result in death, explosion, or fire.
NOTES:
■For the refrigerator drawers to be flush with the front of the base cabinets remove any baseboards or moldings from the rear of the opening. See “Product Dimensions” and later in this section “Opening Dimensions (both styles).”
■It is recommended that you do not install the refrigerator drawers near an oven, radiator, or other heat source.
■Do not install in a location where the temperature will fall below 55°F (13°C).
Opening Dimensions (both styles)
■Height dimensions are shown with the leveling legs extended to the minimum height of ¹⁄₄" (6.35 mm) below the refrigerator drawers.
NOTE: When leveling legs are fully extended to 1" (25 mm) below the refrigerator drawers, add ³⁄₄" (19.05 mm) to the height dimensions. See “Product Dimensions.”
■If the floor of the opening is not level with the kitchen floor, shim the opening to make it level with the kitchen floor.
14³⁄₄"
(37.5 cm)
A | 34³⁄₈" (87.3 cm) min. |
| 35" (88.9 cm) max. |
¹⁄₂" 
(1.3 cm)
24"
(60.96 cm) min.
B
24" (60.96 cm) min.
Critical Dimensions:
A. 14³⁄₄" (37.5 cm) utility opening
B. 24" (60.96 cm) minimum opening width
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Before you move your refrigerator drawers into the final location, it is important to make sure you have the proper electrical connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15- or
IMPORTANT: If this product is connected to a GFCI (Ground Fault Circuit Interrupter) equipped outlet, nuisance tripping of the power supply may occur, resulting in loss of cooling. Food quality and flavor may be affected. If nuisance tripping has occurred, and if the condition of the food appears poor, dispose of it.
5