Dishwasher Feedback Section
CONTROLS AND CYCLE STATUS
CONTROL | PURPOSE | COMMENTS | ||
|
|
|
|
|
|
|
| The Cycle Status Indicator | Clean indicator glows when a cycle is finished. |
|
|
| Lights are used to follow the | If you select the Sani Rinse option, when the Sani Rinse cycle is finished, |
|
|
| progress of the dishwasher | |
|
|
| the Sanitized indicator glows. If your dishwasher did not properly sanitize | |
|
|
| cycle. They are located on | |
|
|
| your dishes, the light flashes at the end of the cycle. This can happen if the | |
|
|
| the top of the door. | |
|
|
| cycle is interrupted, or the water could not be heated to the required | |
|
|
|
| |
|
|
|
| temperature. |
|
|
|
| The Clean and Sanitized lights go off when you open and close the door or |
|
|
|
| press and hold CANCEL/DRAIN. |
|
|
|
|
|
|
|
| The Cycle Status Display is | The indicators will inform you if you are able to add a dish to the cycle after |
|
|
| ||
|
|
| used to follow the progress | it has started. It will also inform you if the dishwasher is washing, rinsing, |
|
|
| of the dishwasher cycle, and | drying, complete, and/or sanitized. They will show whether the control is |
|
|
| to show other information. | locked and/or the delay option is selected. A series of bars will count down |
|
|
|
| the duration of the cycle remaining from left to right. Each bar equals |
|
|
|
| approximately 24 minutes of cycle length. The bars will also count down |
|
|
|
| the delay feature from left to right, and the delay indicator will be activated. |
|
|
|
| After every 30 cycles, the dishwasher will display “affresh,” providing a |
|
|
|
| temporary reminder for you to perform a monthly maintenance procedure. |
|
|
|
| See “Dishwasher Care” section. |
|
|
|
|
|
Canceling a Cycle
1.Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2.Press and hold CANCEL/DRAIN button once. The Cancel/ Drain light will light up.
3.Close the door and the dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
Changing a Cycle After Dishwasher Is Started
1.You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
2.Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
3.Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle.
4.Press and hold CANCEL/DRAIN twice to reset the control.
5.Select new cycles and options.
6.Press START/RESUME.
Adding a Dish After Dishwasher Is Started
1.Check if the Add Dish indicator is lit on the Cycle Status Display.
2.Open the door slightly to stop the cycle. Wait for the spraying action to stop, and then open the door completely.
3.Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and adding a dish is not recommended.
4.If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
5.Press START/RESUME.
11