Frymaster BIELA14 manual Error Log Codes, Explanation, 1-35, Error Message

1.14.4 Error Log Codes

Refer to page 1-39, level 2 program for access to the E-log. The ten most recent errors are listed from A-J, with A being the most recent error.

Code	ERROR MESSAGE	EXPLANATION
E01	REMOVE DISCARD (Right)	A product cook is started on the right side of a split
		vat or in a full vat that has a different setpoint other
		than the current vat temperature.
E02	REMOVE DISCARD (Left)	A product cook is started on the right side of a split
		vat or in a full vat that has a different setpoint other
		than the current vat temperature.
E03	ERROR TEMP PROBE FAILURE	Temp probe reading out of range
E04	HI 2 BAD	High limit reading is out of range.
E05	HOT HI 1	High limit temperature is past more than 410°F
		(210°C), or in CE countries, 395°F (202°C)
E06	HEATING FAILURE	A component has failed in the high limit circuit such
		as computer, interface board, contactor or open-
		high limit.
E07	ERROR MIB SOFTWARE	Internal MIB software error
E08	ERROR ATO BOARD	MIB detects ATO board connection lost; ATO
		board failure
E09	ERROR PUMP NOT FILLING	Oil not returning to vat quickly. Possible problems:
		dirty pad, bad or missing O-rings, tripped or
		defective filter pump, actuators or linkage.
E10	ERROR DRAIN VALVE NOT OPEN	Drain valve failed to open; the valve’s position is
		unknown.
E11	ERROR DRAIN VALVE NOT CLOSED	Drain valve failed to close; the valve’s position is
		unknown.
E12	ERROR RETURN VALVE NOT OPEN	Return valve failed to open; the valve’s position is
		unknown.
E13	ERROR RETURN VALVE NOT CLOSED	Return valve failed to close; the valve’s position is
		unknown.
E14	ERROR AIF BOARD	MIB detects AIF missing; AIF board failure
E15	ERROR MIB BOARD	Cooking computer detects MIB connections lost;
		Check software version on each computer. If
		versions are missing, check CAN connections
		between each computer; MIB board failure
E16	ERROR AIF PROBE	AIF RTD reading out of range
E17	ERROR ATO PROBE	ATO RTD reading out of range
E18	Not currently used
E19	M3000 CAN TX FULL	Connection between computers lost
E20	INVALID CODE LOCATION	SD card removed during update
E21	FILTER PAD PROCEDURE ERROR	25 hour timer has expired or dirty filter logic has
	(Change Filter Pad)	activated
E22	OIL IN PAN ERROR	The MIB has reset the oil in pan flag.
E23	CLOGGED DRAIN (Gas)	Vat did not empty during filtration
E24	AIF BOARD OIB FAILED (Gas)	Oil is back sensor failed.
E25	RECOVERY FAULT	Recovery time exceeded maximum time limit.
E26	RECOVERY FAULT CALL SERVICE	Recovery time exceeded maximum time limit for
		two or more cycles.
E27	LOW TEMP ALARM	Oil temperature has dropped lower than 15°F (8°C)
		in idle mode or 45°F (25°C) in cook mode.

1-35