Frymaster BIELA14 Probable Causes, Problem, Corrective Action, Energy, Misconfigured, Exception

Problem	Probable Causes
M3000 display shows
ENERGY	Wrong energy type selected in setup.
MISCONFIGURED
M3000 display shows
EXCEPTION	An error has occurred.
ERROR with the
description on the right.
M3000 displays
SERVICE	An error has occurred.
REQUIRED followed
by the error.
M3000 display is in
wrong temperature	Incorrect display option programmed.
scale (Fahrenheit or
Celsius).
M3000 displays	Filter error has occurred, filter pad
	clogged, 24 hour filter pad change prompt
CHANGE FILTER
PAD.	has occurred or change filter pad was
	ignored on a prior prompt.
M3000 display shows	A. Filter pan is not fully inserted into fryer.
INSERT pan.	B. Missing filter pan magnet.
	C. Defective filter pan switch.
M3000 display shows	Frypot temperature is more than 410ºF
	(210ºC) or, in CE countries, 395ºF
hot-hi-1.
	(202ºC).
M3000 display shows	Computer in high-limit test mode.
HI-LIMIT.
M3000 display shows
low temp	Frypot temperature is between 180°F
alternating with MLT-	(82°C).
CYCL.
M3000 display shows	Defective SD Card
ERROR RM SDCRD

Corrective Action

Press 1234 to enter setup and set energy type for electric.

Press 1234 to enter setup and reconfigure the computer.

Press YES to silence alarm. The error is displayed three times. See list of issues in section 1.14.3. Fix issue. The computer displays SYSTEM ERROR FIXED? YES/NO. Press YES. Computer displays ENTER CODE. Enter 1111 to clear error code. Pressing NO will allow the fryer to cook but the error will be redisplayed every 15 minutes.

See section 1.14.2 on page 1-33 to change temperature scale.

Change the filter pad and ensure the filter pan has been removed from the fryer for a minimum of 30 seconds.

Do NOT ignore CHANGE FILTER PAD prompts.

A.Pull filter pan out and fully reinsert into fryer.

B.Ensure the filter pan magnet is in place and if missing replace.

C.If the filter pan magnet is fully against the switch and computer continues to display INSERT pan, switch is

possibly defective.

This in an indication of a malfunction in the temperature control circuitry, including a failure of the high-limit thermostat.

This is displayed only during a test of the high-limit circuit and indicates that the high- limit has opened properly.

This display is normal when the fryer is first turned on while in the melt cycle mode. To bypass the melt cycle press and hold either #1 or #2 cook button under the LCD display until a chirp is heard. The computer displays EXIT MELT alternating with YES NO. Press the #1 YES button to exit melt. If the display continues, the fryer is not heating.

Replace card with another card.

1-31