Frymaster BIELA14 Interface Board Diagnostic Chart, Diagnostic LED Legend, PN 826-2260, 1-42

1.17 Interface Board Diagnostic Chart

The following diagram and charts provide ten quick system checks that can be performed using only a multimeter.

	Diagnostic LED Legend
CMP	indicates power from 12V transformer
24	indicates power from 24V transformer
HI	(RH) indicates output (closed) from right latch
	relay
HI	(LH) indicates output (closed) from left latch
	relay
HT	(RH) indicates output from right heat relay
HT	(LH) indicates output from left heat relay
AL	(RH) indicates output (open) from right latch
	relay
AL	(LH) indicates output (open) from left latch
	relay

PN 826-2260 (106-6664)

NOTE – Pin 1 is located in the bottom right corner of

Both J1 and J2. These test points are ONLY for LOV™

Series boards with J1 and J2 plugs on the front of the board.

Meter Setting	Test	Pin	Pin	Results
12 VAC Power	50 VAC Scale	3 of J2	1 of J2	12-16 VAC
24 VAC Power	50 VAC Scale	2 of J2	Chassis	24-30 VAC
*Probe Resistance (RH)	R X 1000 OHMS	11 of J2	10 of J2	See Chart
*Probe Resistance (LH)	R X 1000 OHMS	1 of J1	2 of J1	See Chart
High-Limit Continuity (RH)	R X 1 OHMS	9 of J2	6 of J2	0 - OHMS
High-Limit Continuity (LH)	R X 1 OHMS	6 of J1	9 of J1	0 - OHMS
Latch Contactor Coil (RH)	R X 1 OHMS	8 of J2	Chassis	3-10 OHMS
Latch Contactor Coil (LH)	R X 1 OHMS	5 of J1	Chassis	3-10 OHMS
Heat Contactor Coil (RH)	R X 1 OHMS	7 of J2	Chassis	11-15 OHMS
Heat Contactor Coil (LH)	R X 1 OHMS	4 of J1	Chassis	11-15 OHMS

* Disconnect 15-Pin harness from the computer before testing the probe circuit.

1-42