Frymaster 8195915 operation manual Cleaning, Reassembly

Page 22

4.4Disassembly and Reassembly of the Magnasol Filter Dissassembly

1.Grasp the frame with your thumbs on the handles at the corner of the assembly and pull outward in opposite directions to separate the frame at the corner. Continue to open the frame (it will

pivot at the opposite corner) until the outer screens and grid can be removed from the frame.

Step 2 - Separate the outer screens and grid.

Step 1 - Grasp frame with thumbs on these handles and pull frame appart at corner.

2. Separate the outer screens and grid.

Cleaning

1.Clean the two frame pieces, outer screens, and grid using a good quality degreaser and hot water from a spray nozzle. The groove in the seal frame pieces can be cleaned with the edge of a Scotch-Brite™ or similar cleaning pad.

2.At each scheduled boil-out, disassemble the leaf filter assembly and place in the frypot being boiled out. Follow the boil-out procedure in Section 5.1.2 of this manual.

3.Allow all filter assembly components to air dry or thoroughly dry with clean towels before reassembling.

Reassembly

1.Place the two outer screens together and align their edges (see illustration on following page).

2.Insert the screens into one of the frame halves (it doesn’t matter which one). Ensure that the fitting in the bottom screen is on the opposite side of the frame from the handle.

3.Slip the grid between the screens, ensuring that the grid is centered between the edges of the screens.

4.Connect the other half of the frame at the corner opposite the handles and pivot the frame onto the free edges of the screen.

4-8

Image 22
Contents Hour Service Hotline PRO Series Electric FryersCanada Page Table of Contents PRO Series Electric Fryers Introduction Safety InformationGeneral Computer Information European Community CE Specific InformationService Information PRO Series Electric Fryers Installation Instructions Australia AWGPage Page Setup Equipment Setup and Shutdown ProceduresPRO Series Electric Fryers Operating Instructions Shutdown ControllersPage PRO Series Electric Fryers Filtration Instructions Page Preparation for Use with Filter Paper or Filter Pad Preparation for Use with the Magnasol Filter Assembly Use filter powder with the padPage Snap the Power Shower into position Filter Pump Reset Switch Cleaning ReassemblyDraining and Disposing of Waste Oil PRO Series Electric Fryers Preventative Maintenance Gasket Page Fryer Annual/Periodic System InspectionBuilt-In Filtration System Page PRO Series Electric Fryers Operator Troubleshooting IntroductionActivate Troubleshooting Control and Heating ProblemsController wont Fryer does not heatFryer repeatedly When first startedHeat indicator on Cycles on and offError Messages and Display Problems CM III frypot Temperature isDisplayed constantly Digital controller Temperature scaleHeating mode light Display is in wrongBasket Lift Problems Filtration ProblemsBut oil return is very Power ShowerPower Shower not Slow and bubblingThis page Intentionally Left Blank Service Hotline