Frymaster 8195915 operation manual PRO Series Electric Fryers Installation Instructions, General

Page 8

PRO SERIES ELECTRIC FRYERS

CHAPTER 2: INSTALLATION INSTRUCTIONS

2.1General

Proper installation is essential for the safe, efficient, trouble-free operation of this appliance. Any unauthorized alteration of this equipment will void the Frymaster warranty.

NOTICE

If this equipment is wired directly into the electrical power supply, a means for disconnection from the supply having a contact separation of at least 3-mm in all poles must be incorporated in the fixed wiring.

NOTICE

This equipment must be positioned so that the plug is accessible unless other means for disconnection from the power supply (e.g., a circuit breaker) is provided.

NOTICE

If this appliance is permanently connected to fixed wiring, it must be connected by means of copper wires having a temperature rating of not less than 167°F (75°C).

NOTICE

If the electrical power supply cord is damaged, it must be replaced by a Frymaster Dean Factory Authorized Service Center technician or a similarly qualified person in order to avoid a hazard.

DANGER

This appliance must be connected to a power supply having the same voltage and phase as specified on the rating plate located on the inside of the appliance door.

DANGER

All wiring connections for this appliance must be made in accordance with the wiring diagram(s) furnished with the appliance. Refer to the wiring diagram(s) affixed to the inside of the appliance door when installing or servicing this equipment.

DANGER

Frymaster appliances equipped with legs are for stationary installations. Appliances fitted with legs must be lifted during movement to avoid damage to the appliance and bodily injury. For movable installations, optional equipment casters must be used. Questions? Call 1-800-551-8633.

2-1

Image 8
Contents Hour Service Hotline PRO Series Electric FryersCanada Page Table of Contents General Safety InformationPRO Series Electric Fryers Introduction Computer Information European Community CE Specific InformationService Information PRO Series Electric Fryers Installation Instructions Australia AWGPage Page PRO Series Electric Fryers Operating Instructions Equipment Setup and Shutdown ProceduresSetup Shutdown ControllersPage PRO Series Electric Fryers Filtration Instructions Page Preparation for Use with Filter Paper or Filter Pad Preparation for Use with the Magnasol Filter Assembly Use filter powder with the padPage Snap the Power Shower into position Filter Pump Reset Switch Cleaning ReassemblyDraining and Disposing of Waste Oil PRO Series Electric Fryers Preventative Maintenance Gasket Page Built-In Filtration System Annual/Periodic System InspectionFryer Page PRO Series Electric Fryers Operator Troubleshooting IntroductionTroubleshooting Control and Heating Problems Controller wontActivate Fryer does not heatWhen first started Heat indicator onFryer repeatedly Cycles on and offError Messages and Display Problems Displayed constantly Temperature isCM III frypot Temperature scale Heating mode lightDigital controller Display is in wrongBasket Lift Problems Filtration ProblemsPower Shower Power Shower notBut oil return is very Slow and bubblingThis page Intentionally Left Blank Service Hotline