Frymaster 8195915 Digital controller, Display is in wrong, Temperature scale, Trouble light on

Page 34

Problem

Probable Causes

Corrective Action

Digital controller

 

Digital controllers are manually set

 

to display in one temperature scale

display is in wrong

 

 

or the other. Refer to the separate

temperature scale

Incorrect display option selected.

Frymaster Fryer Controllers

(Fahrenheit or

 

 

User's Manual for instructions on

Celsius).

 

 

changing the display.

 

 

 

 

Verify that the drain valve is fully

Digital controller

 

closed. If the drain valve is fully

Open drain valve or problem with

closed, the problem is within the

display shows

latching circuits

latching circuitry and is beyond the

.

 

scope of operator trouble shooting.

 

 

 

 

Call FASC.

 

 

This in an indication of a

Digital controller

Frypot temperature is more than

malfunction in the temperature

control circuitry, including a

410°F (210°C) or, in CE countries,

display shows .

failure of the high limit thermostat.

395°F (202°C).

 

Shut the fryer down immediately

 

 

 

 

and call FASC.

Digital controller

 

This indicates a problem within the

Problem with the temperature

temperature measuring circuitry

display shows

measuring circuitry including the

that is beyond the scope of

.

probe.

operator troubleshooting. Shut the

 

 

fryer down and call FASC.

 

 

This in an indication of a

 

 

malfunction in the temperature

 

 

measuring or control circuitry,

Solid state controller

Oil temperature above acceptable

including a failure of the high limit

range or a problem with the

thermostat. Determining the

trouble light ON.

temperature measuring circuitry.

specific problem is beyond the

 

 

 

scope of operator troubleshooting.

 

 

Shut the fryer down immediately

 

 

and call FASC.

 

 

Verify that the drain valve is fully

Solid state controller

 

closed. The fryer will not function

 

if the drain valve is not fully

trouble light ON and

Open drain valve or problem with

closed. If the drain valve is fully

heating mode light

latching circuits

closed, the problem is within the

ON.

 

latching circuitry and is beyond the

 

 

scope of operator troubleshooting.

 

 

Call FASC.

6-6

Image 34
Contents Hour Service Hotline PRO Series Electric FryersCanada Page Table of Contents PRO Series Electric Fryers Introduction Safety InformationGeneral Computer Information European Community CE Specific InformationService Information PRO Series Electric Fryers Installation Instructions Australia AWGPage Page Setup Equipment Setup and Shutdown ProceduresPRO Series Electric Fryers Operating Instructions Shutdown ControllersPage PRO Series Electric Fryers Filtration Instructions Page Preparation for Use with Filter Paper or Filter Pad Preparation for Use with the Magnasol Filter Assembly Use filter powder with the padPage Snap the Power Shower into position Filter Pump Reset Switch Cleaning ReassemblyDraining and Disposing of Waste Oil PRO Series Electric Fryers Preventative Maintenance Gasket Page Fryer Annual/Periodic System InspectionBuilt-In Filtration System Page PRO Series Electric Fryers Operator Troubleshooting IntroductionActivate Troubleshooting Control and Heating ProblemsController wont Fryer does not heatFryer repeatedly When first startedHeat indicator on Cycles on and offError Messages and Display Problems CM III frypot Temperature isDisplayed constantly Digital controller Temperature scaleHeating mode light Display is in wrongBasket Lift Problems Filtration ProblemsBut oil return is very Power ShowerPower Shower not Slow and bubblingThis page Intentionally Left Blank Service Hotline