Frymaster 8195915 operation manual

Page 3

DANGER

Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.

DANGER

The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the end of frying operations each day. Some food particles can spontaneously combust if left soaking in certain shortening material. Additional information can be obtained in the filtration manual included with the system.

WARNING

Do not bang fry baskets or other utensils on the fryer’s joiner strip. The strip is present to seal the joint between the fry vessels. Banging fry baskets on the strip to dislodge shortening will distort the strip, adversely affecting its fit. It is designed for a tight fit and should only be removed for cleaning.

NOTICE

All fryers shipped without factory supplied cords and plug assemblies must be hardwired using flexible conduit to the terminal block located on the rear of the fryer. These fryers should be wired to NEC specifications. Hardwired units must include installation of restraint devices.

DANGER

Single fryers equipped with legs must be stabilized by installing anchor straps. All fryers equipped with casters must be stabilized by installing restraining chains

DANGER

Adequate means must be provided to limit the movement of this appliance without depending on or transmitting stress to the electrical conduit. A restraint kit is provided with the fryer. If the restraint kit is missing contact your local Frymaster Factory Authorized Service Center (FASC) for part number 826-0900.

DANGER

This fryer may have two power cords and prior to movement, testing, maintenance and any repair on your Frymaster fryer; disconnect BOTH electrical power cords from the electrical power supply.

Image 3
Contents PRO Series Electric Fryers Hour Service HotlineCanada Page Table of Contents Safety Information PRO Series Electric Fryers IntroductionGeneral European Community CE Specific Information Computer InformationService Information PRO Series Electric Fryers Installation Instructions AWG AustraliaPage Page Equipment Setup and Shutdown Procedures SetupPRO Series Electric Fryers Operating Instructions Controllers ShutdownPage PRO Series Electric Fryers Filtration Instructions Page Preparation for Use with Filter Paper or Filter Pad Use filter powder with the pad Preparation for Use with the Magnasol Filter AssemblyPage Snap the Power Shower into position Filter Pump Reset Switch Reassembly CleaningDraining and Disposing of Waste Oil PRO Series Electric Fryers Preventative Maintenance Gasket Page Annual/Periodic System Inspection FryerBuilt-In Filtration System Page Introduction PRO Series Electric Fryers Operator TroubleshootingFryer does not heat Troubleshooting Control and Heating ProblemsController wont ActivateCycles on and off When first startedHeat indicator on Fryer repeatedlyError Messages and Display Problems Temperature is CM III frypotDisplayed constantly Display is in wrong Temperature scaleHeating mode light Digital controllerFiltration Problems Basket Lift ProblemsSlow and bubbling Power ShowerPower Shower not But oil return is veryThis page Intentionally Left Blank Service Hotline