Frymaster 8195915 Fryer repeatedly, Cycles on and off, When first started, After filtering

Problem	Probable Causes	Corrective Action
		This is normal for fryers equipped
		with CM III computers, Basket
		Lift Timers, and Digital
		Controllers. The default
		operational mode for these
		controllers is for the elements to
		cycle on and off until the
		temperature in the frypot reaches
		180ºF (82ºC). In CM III
		computers, CYCL will appear in
		the display when in the melt-cycle
		mode. The purpose of the melt-
		cycle is to allow controlled melting
		of solid shortening to prevent
Fryer repeatedly		scorching and flash fires or damage
		to the element. If you are not using
cycles on and off	Fryer is in melt-cycle mode.	solid shortening, the melt-cycle can
when first started.		be cancelled or bypassed. Refer to
		the separate Frymaster Fryer
		Controllers User's Manual for the
		procedure for canceling the melt-
		cycle for the particular controller
		installed on your fryer.
		In fryers equipped with Solid State
		(Analog) controllers, the melt-
		cycle is controlled manually by
		means of the rocker switch to the
		right of the temperature control
		knob. If not using solid
		shortening, press the rocker switch
		to the OFF position to turn off the
		melt-cycle.
		This fryer is equipped with a drain
Fryer does not heat		safety switch that prevents the
	Drain valve is open.	heating element from being
after filtering.		energized if the drain valve is not
		fully closed. Verify that the drain
		valve is fully closed.
		Turn fryer off and call FASC.
Fryer heats until	Temperature probe or controller has
high limit trips with
	failed.
heat indicator ON.

6-3