About the automatic icemaker. | ge.com |
A
Safety
There are 2 types of icemakers:
Power
Switch
Icemaker
Green | Feeler Arm |
Power Light |
Power switch model
Feeler Arm in
the STOP
Feeler Arm in (up) position the ON (down)
position
Feeler arm model
Automatic Icemaker (on some models)
The icemaker will produce approximately 3 to 31⁄2 lbs. of ice in a
There are two types of icemakers: power switch models and feeler arm models.
If the refrigerator is operated before the water connection is made to the icemaker, set the power switch to O (off) or move the feeler arm to the STOP (up) position.
When the refrigerator has been connected to the water supply, set the power switch to the I (on) position or move the feeler arm to the ON (down) position. On power switch models, the green light will come on.
The icemaker will fill with water when it cools to 15°F. A
Once the icemaker starts to make ice,
it may take up to 48 hours to fill the bin, depending on the temperature settings and number of door openings.
You will hear a buzzing sound each time the icemaker fills with water.
Throw away the first few batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become cloudy, taste stale, shrink or fuse together.
On power switch models, the green power light will blink if ice cubes get stuck in the icemaker. To correct this, set the power switch to O (off) and remove the cubes. Set the power switch to I (on) to restart the icemaker. After the icemaker has been turned on again, there will be a delay of about 45 minutes before the icemaker resumes operation.
NOTE: In homes with
Instructions Operating Instructions Installation Instructions
Icemaker Accessory Kit
If your refrigerator did not already come | Check the back of the refrigerator for the |
equipped with an automatic icemaker, | specific icemaker kit needed for your model. |
an icemaker accessory kit is available at |
|
extra cost. |
|
This refrigerator will accept accessory icemaker IM4A or IM6. Use instruction sheet L supplied in the kit for assembly inside freezer compartment.
To facilitate installation of an icemaker kit, the following parts are included with your refrigerator:
Part | Part Number |
Ice Fill Cup | WR29X10074 |
Ice Fill Tube | WR17X12339 |
Ice Fill Tube Seal | WR17X12337 |
NOTE: It is important that you DO NOT discard these parts, as they will be needed if you plan to install accessory icemaker kit IM4A or IM6.
9