GE GTH21, GTL21 Rehang the Refrigerator Door, Rehang the Freezer Door, Adjust the Doors if Needed

Installation Instructions

8REHANG THE REFRIGERATOR

DOOR

Lower the refrigerator door onto the bottom hinge pin.

Plastic

Washer

Screw the two screws into the center hinge location on the left side with a 5/16″ socket and ratchet.

Straighten the door and place the center hinge pin into the opening on top of the door. Remember to include the washer.

Move the door into place, so you can align the center hinge bracket over the center hinge holes on the left side. Insert and tighten the two screws with a 5/16″ socket and ratchet.

NOTE: Ensure the washer is in place on top of the hinge pin.

Plastic Washer

Hinge Pin

Center Hinge

Bracket

Refrigerator Door

9REHANG THE FREEZER DOOR

Lower the freezer door onto the center hinge pin.

Be sure the washer is in place.

Center Hinge Pin

Plastic

Washer

Lift the top hinge so the pin fits into the door socket.

Support the door on the handle side and make sure the door is straight and the gap between the doors is even across the front. While holding the door in place, tighten the top hinge screws.

10 ADJUST THE DOORS (IF NEEDED)

If the freezer door is too high:

Remove the hinge
cover on top of the	Loosen screws. 5/16″
freezer door and

loosen the four screws with a 5/16″ socket and ratchet. Replace the hinge cover.

If both doors are too high:

1.Remove

the hinge

cover on	Loosen screws. 5/16″
top of the
freezer
door and	5/16″
loosen the
four screws
with a	Loosen
″	screws and
5/16

socket and	slide left to
	lower doors.
ratchet.

2.Loosen the two center hinge screws with a 5/16″ socket and ratchet.

3.Slide the center hinge to the left to lower the doors.

4.Fully tighten all screws and replace top hinge cover.

If both doors are too low:

1.Remove the

hinge cover

on top of	Loosen screws. 5/16″
the freezer
door and
loosen the	5/16″
four screws
with a 5/16″
socket and	Loosen
ratchet.
	screws and
2. Loosen the
	slide right to
two center	raise doors.

hinge screws

with a 5/16″ socket and ratchet.

3.Slide the center hinge to the right to raise the doors.

4.Fully tighten all screws and replace top hinge cover.

NOTE: Save the door spacer.

Doors may settle with use.

Door Spacer

25