Bosch Appliances 800 Series Leveling Procedure, Clockwise Transport, such As when, Moving out

q A center-located bubble indicates the unit is leveled. Otherwise, repeat the leveling procedure until the unit is leveled. Tip: if the bubble is closer to one end, it indicates the high side of the unit. To level the unit, either lower the higher side or raise the lower side.

q After leveling the unit from side to side, then turn the level so that it lays on the worktop from front to back to also check the level in that direction.

Fine tune the leveling by placing a small load of laundry in the machine, starting it in spin cycle and then leveling the washer again.

If the test spin cycle is manually

stopped before its completion, then the door may remain locked for 10 seconds.

Leveling Procedure

1.The appliance should now be in its final position, ready for leveling (moving the appliance after

leveling can make it unlevel again.)

Each foot of the appliance or pedestal must be placed firmly on the floor to prevent the washing machine from wobbling.

Start with all four feet screwed in as far as possible, then back individual feet out as necessary to level the washer.

2.Use the bubble level to level the washer front to back and side to side (be sure the level fits between the edges of the washer, and is not elevated at one end on a ridge on the surface of the washer.)

3.Adjust the leveling of the washer with the four height-adjustable feet. Level the washer as low as possible to help reduce vibration.

dCAUTION

TO	AVOID	RISK	OF INJURIES-Take	4.
care	when	using	the wrench.

q Loosen the lock nut1 on( the illustration) by turning it clockwise. Use the wrench provided (or a 5/8" - 16mm open end wrench). When you turn the lock nut, the 2footn ( the illustration) it is locked against will turn with it. This will extend the height of the foot.

5.

i

q Turning the foot out	(clockwise) Transport, such		as when
will raise the corner	of the	moving out
washer, turning the foot in
(counter-clockwise) will lower		Before transporting the	washing
the corner of the washer.		machine:

When

the

corner

of

the

washer-

Turn

off the

water.

is satisfactorily

raised

or

-

Disconnect

the

washing machine

lowered, lock

the

from

the

power

outlet.

height-adjustable feet

in

place

-

Dismantle

the

supply and drainage

by turning

the

lock

nut

hoses.

counter-clockwise until it locks

-

Install

the

transport bolts.

tightly

against

the

washer

housing.

may be necessary to holdPreparing

and

inserting

the

i

It

the washer foot with a pair transport

bolts

of pliers to keep it from

turning while tightening the

lock nut. It the foot does

turn, it will change the

height of

the corner.

q After

making

preliminary

adjustments,

press down on

each corner of the washer to

make sure the unit does not

q

Remove

the

covers.

wobble. If it does wobble,

Prepare

the

transport

bolts:

lower the foot on that corner

q

until the foot touches the floor

Loosen the screw in the sleeve

firmly.

until

the

end

of

the

screw

is

level

Use a bubble level (24" or less in

with

the

end

of

the

sleeve.

Insert and tighten all transport

length)

to check the leveling statusq

of the

appliance.

bolts.

Make

sure

that

the

tab

on

the transportation

bolt

is inserted

q Lay

the bubble level across the

in the slot on the washing machine

unit worktop to check the level

back

panel.

from

side to

side and from front

to

back.

11