Bosch Appliances 800 Series manual Water drainage Standpipe Installation Drainage into a sink

Water drainage Standpipe Installation Drainage into a sink

ATTENTION

Do not bend or pull the water drainage hose.

Height difference between the installation location of the washing machine and the drainage point: Maximum 8 feet / 244 cm, minimum 2 feet / 60 cm.

ATTENTION

Ensure that the plug is not in the drain hole.

Connecting		the	water			Use the elbow. Attach the elbow to
drainage	hose				q
q Do not	remove		the screw	from		the end of the hose and insert end
						of hose		into standpipe.
the clamp assemblyLoosen.				the	q	Use a strap or cable tie to hold
screw only enough so that the
						hose	in	place.
clamp will slide freely onto the									q Attach water drain hose securely
water drain		hose.			In-Wall		Installation
									to sink.
									q Use a strap or cable tie to hold
									hose in	place.
									q When the water is being drained,
									check that the water flow out of
									the sink	is adequate.

qUse the elbow. Attach the elbow to the end of the hose and insert the end of the hose into the wall drain.

qThe hose and elbow should

1.Place the hose clamp over the end extend into the open drain pipe as

of the drain hose before attaching far as the elbow allows when

the drain hose to the appliance.	seated as shown in the above
	picture.

qUse a strap or cable tie to hold hose in place.

Drainage into a siphon

2.Attach the drain hose to the drainq hose connection on theback of

the appliance; position the hose clamp approximately 3/8 inch (9

mm)from the end of the hose.

3.Tighten the clamp with a screwdriver

Secure the connection point with a hose clip(not included in factory-supplied equipment).

9