Tips on Saving Energy
- Install the Appliance Properly
In other words, away from sources of heat and direct sun- light, in a well ventilated room complying with the mini- mum distances indicated in the paragraph entitled, “ Instal- lation/Ventilation.”.
THE ACTUAL ENERGY CONSUMPTION OF THE APPLIANCE DEPENDS ON THE WAY THE SAME IS USED AND ON ITS LOCATION.
The consumption tests were performed in 560mm deep column units, the most common installation setting for this appliance.
- Use the Right Temperature Setting
A setting which is too cold increases energy consumption.
- Do not Overfill
To conserve food properly, the cold air must circulate freely within the refrigerator. If it is overfilled, this will prevent proper air circulation, forcing the compressor to work continuously.
- Close the Doors
Open your refrigerator as little as possible because each time you do so you loose much of the cold air. To raise the tem- perature to the proper level again, the motor must work for a long time, consuming energy.
- Keep an Eye on the Seals
Keep the seals clean and make sure that they adhere well to the door. This alone will ensure that no cold air escapes.
- No Hot Foods
A hot pot or pan placed in the refrigerator immediately raises the temperature several degrees. Let hot cookware and food cool to ambient temperature before placing them in the re- frigerator.
- Defrost the Freezer
Check the thickness of the frost on the walls of the freezer and immediately defrost it if the layer of frost is too thick. (see the section entitled, “Keeping your Appliance in Shape”).
Keeping Your Appliance in Shape
Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug or turning off the general switch in your home).
Defrosting
WARNING: do not damage the refrigeration circuit. Do not use mechanical devices or other tools to speed up the defrosting process, unless they have been rec- ommended by the manufacturer.
How to Defrost the Refrigerator
This appliance defrosts automatically and the water is channeled to the back toward the drain installed for this purpose (fig. 2). Here, the heat produced by the compressor will make it evaporate. The only thing you must do is to periodically check and clean the hole of the drain, which is located behind the vegetable crispers, so that the water drains properly.
How to Defrost the Freezer
-Every so often, remove the frost with the scraper provided with the appliance (do not use knives or metal objects).
-If the frost is more than 15 mm thick, the freezer must be defrosted.
Proceed as follows: turn the thermostat knob (G ) to the · setting "0" (Fig. 3). Then wrap all the frozen and
The unit is provided with a system which allows the defrost water to be collected in a container to be placed beneath the unit (proceed as illustrated in fig. 4).
Fig. 3 | Fig. 4 |
Fig. 2