Aiwa AV-D77 manual About the Remote Control, Remote control operation

ABOUT THE REMOTE CONTROL

Inserting batteries

Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries.

When to replace the batteries

The maximum operational distance between the remote control and the sensor on the unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones.

Important

•The ENTER buttons on the remote control do not substitute for the ENTER button on the main unit. They are for operating AIWA DVD players or other audio/video equipment.

•In principal, the UP and DOWN buttons on the remote control substitute for the N and M buttons on the main unit except when selecting the TUNER function.

NOTE

•If the unit is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage.

•The remote control may not operate correctly when:

-The line of sight between the remote control and the remote sensor in the display window is exposed to intense light, such as direct sunlight.

-Other remote controls are used nearby (those of a television, etc.)

Remote control operation

This remote control system allows you to operate other external
equipment besides the AIWA receiver. For details of the remote	PREPARATIONS
control operation for other external equipment, see “REMOTE

CONTROL” on page 20.

The following is an explanation on how to operate the AIWA receiver and the AIWA DVD players.

1 Press the AIWA RECEIVER button to set the remote control to the AIWA receiver mode.

2 Press one of the buttons indicated above.
FUNCTION button
Each time this button is pressed, the sound source changes
cyclically.
TUNER PRESET/SURROUND buttons
	En
Tune in the station which has been preset on the receiver.
To go to a higher preset number, press the UP button. To go to
a lower preset number, press the DOWN button.
This button is also used when adjusting the speaker level
balance of DOLBY SURROUND, DTS SURROUND or DSP
surround etc.
NOTE
It is not necessary to press the AIWA RECEIVER button each
time you operate the AIWA receiver unless another mode has
already been set. (See “REMOTE CONTROL” on page 20.)
Operating AIWA DVD players
You can control basic functions of AIWA DVD players with the
remote control. In principle, the AIWA DVD buttons have the same
function as those on the DVD players.
For more details, refer to the operating instructions of the player.
If the receiver cannot be operated with the remote
control
Follow the steps below using the remote control.

1Press the AIWA RECEIVER button.

2Press and hold the SET UP button for about 3

seconds.

The indicator on the top of the remote control blinks twice while pressing the button.

3Press the DIGIT buttons in the order of “0,” “4,” “0” and “6.”

ENGLISH 6