Pitco Frialator L22-355 Hold Pre-Alarm, Spin Time, Spin Rate, To Exit Level 1 programming

Page 9

Spin Fryer I12 Cooking Computer

Pitco P/N 60149505

2.2.4Hold Pre-Alarm

Hold Pre-Alarm is a timer setting that is used to warn operators that the Hold Time is about to expire. To use Hold Pre-Alarm, the time value must be a non-zero value, and, must be set to a value less than Hold Time. Default value is zero, meaning the Hold Pre-Alarm is inactive.

Display shows [nPA mm:ss] [TIME] where “n” is the key number, PA means Pre-Alarm, and “mm:ss” is minutes and seconds.

Use the product keys for numeric entry to adjust the current setting. Press the key to save pre-alarm time. Note: Value entered for hold pre-alarm time is the time from the end of the hold period.

2.2.5Spin Time

Spin time is the duration that the basket will spin after the cook cycle. The basket will not spin after a cook cycle if the set spin time is set to 0.

Display shows [nST mm:ss] [TIME] where “n” is the key number, ST means Spin Time, and “mm:ss” is minutes and seconds.

Use the product keys for numeric entry to adjust the current setting. Press the key to save spin time.

2.2.6Spin Rate

Spin rate is the maximum speed the basket will spin after the cook cycle. The spin rate value must be between 200 and 500.

Display shows [nSR XXX] [TIME] where “n” is the key number, SR means Spin Rate, and “XXX” is the rate in RPMs.

Use the product keys for numeric entry to adjust the current setting. Press the key to save spin rate.

Display will again return to

. Repeat steps from section

2.2.2to make changes to any other product keys or continue.

2.3To Exit Level 1 programming:

Display shows

.

Press the key. Display shows . Continue to section 3 “To Change Options”, or, exit here in the next step.

To exit Level 1 programming, press the key again.

Displays will show are running.

;

, or

, when no active cooks

Page 9 of 28

L22-355 Rev 1

Image 9

Contents Important Information for Future Reference For Pitco P/N 60149505 Spin FryerTo Enter Programming Level 1 for the Store Manager Spin Fryer I12 Cooking Computer To turn the appliance on To turn the appliance OFFTo start a cook To check Actual and Set temperatures To cancel a cookTo perform a Boil Out operation Automatic Boil Entry Water DetectionManual Boil Entry To Enter Programming Level 1 for the Store Manager To Set Cook TemperatureCook Time Shake TimeHold Time Spin Time Hold Pre-AlarmSpin Rate To Exit Level 1 programmingPassword Change or Required? To Change Options Level 2 for the Store ManagerFahrenheit or Celsius Display Beeper ON/OFF Language SelectionMelt Cycle Type Recovery Test Value Offset the Temperature Display To Enter Programming Level 3 for the TechnicianMelt Cycle on Time Minimum on and OFF Cycle Time Recovery TimesFunction Description Button Diagnostic Menu EntryMore Service Menu Entry Temperature Operating RangeReady Level Instant On ToggleHold Alarm Duration Shake Alarm DurationCancel Duration Configuration ValueStanding Pilot Toggle Factory ResetSet Network Address To Exit Programming LevelOffset Temperature Display Factory Menu Level 4 for the TechnicianPitco Collect toggle Recovery Test Values Operating Temperature RangeHigh Limit Value Used if object becomes stuck during spinning Spin DiagnosticsMore Factory Menu Entry Test On/Off12.1 Control ID Display To Exit Factory Menu LevelSystem / Failure Other DisplaysPage Mechanical Dimensions J1Left Inputs Type Nominal Electrical Connections at Left and Right connectorsProbe Resistance in 5F Increments Probe Resistance ChartOhms Probe ResistanceMailing Address P.O. BOX 501, CONCORD, NH