Removing the Oven Door
CAUTION:
When removing the door:
• Make sure oven is cool and power to the |
oven has been turned off before |
removing the door. Failure to do so could |
result in burns. |
• The oven door is heavy and fragile. Use |
both hands to remove the oven door. The |
door front is glass. Handle carefully to |
avoid breaking. |
• For safe, temporary storage, lay the door |
flat with the inside of the door facing |
down. |
• Grasp only the sides of the oven door. Do |
not grasp the handle as it may swing in |
your hand and cause damage or injury. |
• Failure to grasp the oven door firmly and |
properly could result in personal injury or |
product damage. |
• Do not lay removed door on sharp or |
4. | Firmly grasp both | |
About | sides of oven door | |
10° | along the door sides | |
Oven | (Do not use the oven | |
door handle - see | ||
Door | figure). | |
5. Close the door to the | ||
Door | broil stop position (the | |
oven door will stop | ||
Hinge | ||
| into this position just | |
| before fully closing). | |
6. With the oven door in | ||
| the broil stop position, | |
| lift the oven door hinge | |
| arms over the roller | |
| pins located on each | |
| side of the oven frame | |
| (see figure). |
To replace the oven door:
pointed objects as this could break the |
glass. Lay on a flat, smooth surface, |
positioned so that the door cannot fall |
over. |
To remove the oven door:
1. Be sure to read the above CAUTION before attempting to
Oven Door
About 10°
Door
Hinge
1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - see figure).
remove the door.
2. Open oven door completely (horizontal with floor - see figure)
3. Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (see figure). A tool such as a small
2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (see figure). The hook of the hinge arms must be fully seated onto the roller pins.
English 25