Cuisine-Cookware ZBD0700, ZBD6800, ZBD0710 Lighting, Using the dishwasher, Features on some models

Page 9

Lighting

Using the dishwasher

Dishwasher

Interior Lights (on some models)

Features (on some models)

The interior Xenon lights provide better visibility for loading and unloading. They come on when the door is opened and turn off when the door is latched. The lights will turn off after 15 minutes if the door remains unlatched. To turn the lights back on latch and reopen the door.

End-of-Cycle Indicator Light (on some models)

The end-of-cycle indicator light is located on the right side of the dishwasher, above the handle. This light comes on when the selected cycle and enhancements are complete. The light will stay on until the door is opened. The dishes may be removed at any time.

Do not attempt to replace the bulbs. If light bulb replacement is necessary, please contact the GE Answer Center for service by calling 1.800.626.2000.

Note that the high-efficiency fan will run quietly for 30 minutes to 4 hours (depending on the selected cycle) after the end-of-cycle indicator light is illuminated to continue drying the dishes. Opening the door and pressing any keypad will stop the fan.

Water Temperature

The entering water must be at least 120°F

nearest the dishwasher, place the thermometer

(49°C) and not more than 150°F (66°C), for

in a glass and let the water run continuously into

effective cleaning and to prevent dish damage.

the glass until the temperature stops rising.

Check the water temperature with a candy or

 

meat thermometer. Turn on the hot water faucet

 

Use a Rinse Agent

A rinse agent improves dry performance, reduces spots and prevents new film build-up on your dishes, glasses, flatware, cookware and plastic. Jet-Dry®and Cascade Rinse Aid® are recommended rinse agents for Monogram Dishwashers.

The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill.

To fill the rinse agent dispenser, make sure the dishwasher is fully open.

Turn the dispenser cap to the left and lift it out. Add rinse agent until the indicator window shows full.

Clean up any spilled rinse agent with a damp cloth. Replace the dispenser cap.

The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If there is foaming, use a lower setting.

To adjust the setting, remove the dispenser cap; then turn the adjuster counterclockwise to increase the amount of rinse agent.

Indicator

Dispenser

Rinse agent

adjuster

window

cap

 

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Ge.com Owner’s ManualIntroduction ContentsIf you Need service Before using your dishwasherWrite down the model & serial numbers If you received Damaged dishwasherProper Installation and Maintenance Before You Throw Away Your Old Dishwasher Proper Disposal of the DishwasherControl Panel Control SettingsControl Panel/Operation Time Remaining Display on some models START/RESETFeatures on some models Using the dishwasherWater Temperature LightingForget to Add a Dish? Using the dishwasher DetergentsDo not use hand dish detergent Upper Rack Loading the RacksSilverware Basket Adjustable Upper Rack on some modelsLower Rack Extra Rack Features on some modelsRemove the Upper Rack Cutlery TrayFollow these guidelines for loading 10 and 12 place settings Care and Cleaning Exterior Interior Protect Against FreezingAir Gap Before You Call For Service Questions? Use this problem solverDishes and flatware Not cleanSpots and filming on Use Jet Dry or Cascade Rinse Aid rinse Glasses and flatwareOn inside surfaces Yellow or brown filmWhite film on inside SurfacesSanitized light does not End-of-cycle indicatorIlluminate at the end Cycle Anti-BacteriaCanada, call Consumer ServicesFrom the Date Original Purchase Warranty for customers in the USAONE-YEAR Five YearsWarranty for customers in Canada Registration Ownership Product Consumer Consumer Product Ownership Registration Manuel du propriétaire Table des matières Information pour le consommateurAvant d’utiliser votre lave- vaisselle Si vous devez appeler le serviceÉcrivez les numéros de modèle et de série Si vous Avez reçu un lave-vaisselle endommagéAvertissement Avant de jeter votre vieux lave-vaisselle Avertissement ! Risque D’ENFANT Pris AU PiègeRéglages de contrôle Panneau de contrôleMedium moyennement sale 7,8 gallons, 30 minutes Panneau de contrôle/FonctionnementMedium moyennement sale 7,8 gallons, 105 minutes MarchePanneau de contrôle/Fonctionnement Utilisation du lave-vaisselle Fonctions’éclairage sur certains modèles Température de l’eauDétergents Utilisation du lave-vaisselle La mainVentilateur de séchage sur certains modèles Clayette du haut Chargement des clayettesClayette supérieure ajustable sur certains modèles Panier à argenteriePour mettre la clayette en position inférieure Enlèvement de la clayette supérieure Clayette inférieureAutres caractéristiques de clayette sur certains modèles Tiroir à coutellerieChargement des clayettes Extérieur Intérieur Protection contre le gel Soins et nettoyage’écart anti-retour Avant d’appeler le service Couverts ne sont pas La vaisselle et lesPropres Il y a des taches et uneOu brune sur les surfaces Il y a une pellicule jauneIntérieures Il y a une pellicule blancheCycle cycle anti-bactérien Ne s’allume pas à la fin duSeulement Les lampes intérieures neAu Canada, appelez le Service à la clientèleOwnership Registration Inscription de propriété de produit de consommation UN AN GarantieImprimé aux États-Unis
Top Page Image Contents