Australia
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Do not use the door handles or control knobs to manoeuvre the cooker.
Repositioning the Cooker following
Connection
Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker.
Unfold the rear edge of the pack base tray. Open the grill door and right hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the oven:
Grip under the fascia panel and lift the front of the cooker slightly:
Carefully push the cooker backwards off the pack base. Remove the pack base tray. Position the cooker close to its final position, leaving just enough space to get behind it.
If you need to move the cooker once it has been connected, then you need to unplug it and, having gripped under the fascia panel and lifted the front of the cooker slightly (as shown above), you need to check behind the cooker to ensure that the gas hose is not caught. As you progress, make sure that both the electricity cable and gas hose always have sufficient slack to allow the cooker to move.
Release the stability chain as you ease the cooker out. When you replace the cooker, don’t forget to refit the chain and also check behind to make sure that the electricity cable and gas hose are not caught or trapped.
Conversion to LP
If the appliance is to be converted to LP gas, carry out the conversion at this point. See the conversion section of these instructions.
Levelling
It is recommended that you use a spirit level on a shelf in one of the ovens to check for level. Ensure that the cooker in its intended position, taking care not to twist it within the gap between the kitchen units, as damage may occur to the cooker or the units. The front feet and rear rollers can be adjusted to level the cooker.
To adjust the height of the rear of the cooker, use the levelling tool supplied to turn the adjusting nuts at the front bottom corners of the cooker. To set the front feet, simply turn the bases to raise or lower them.
Leave the levelling tool with the customer, so that they can use it if they wish to move the cooker again.
Fitting the Handles and Front Handrail
Remove the 4mm Allen screws from the doors with the hexagon key tool. Use the screws to fit the door handles.
The handles should be above the fixings.
24