Falcon U109635-02 manual Oven Check, Fitting the Plinth, Customer Care, Thank you, Main Oven Light

Page 29

Australia

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

This shows the single-phase connection.

Fixed Wiring

For connection to fixed wiring, i.e. flexible conduit, remove the electrical terminal cover box on the back panel. Remove two screws and blanking plate from the bottom flange of the cover box, so as to allow the conduit through.

Each burner has an FSD (Flame Security Device) that will stop the flow of gas if the flame goes out.

For each burner, press the ignition switch on the fascia panel and push in and turn the knob to the solid flame symbol ( ).

Keep holding the knob pressed in to let the gas through to the burner for few seconds. If, when you let go of the control knob, the burner goes out, then you have not bypassed the safety device for initial ignition. Turn the control to the off position and wait one minute, then try again, this time holding in the control knob for slightly longer.

Grill

Open the grill compartment door. Turn on the grill control and check that the grill heats up.

Oven Check

Set the clock to the time of day. See 'The Clock' section in the Users section of these instructions.

Turn on the ovens and check that the oven fans start to turn. Turn off the ovens.

Fitting the Plinth

Loosen the three screws along the front bottom edge of the cooker. Hook the central keyhole over the central screw. Twist and fit each end keyhole over their respective screws. Tighten the fixing screws.

Customer Care

Please complete your details in this Guide, make sure that the user knows how to operate the cooker, and hand over the Instructions.

Thank you.

Fix the conduit-to-conduit mounting bracket on the back panel. Connect the mains cable to the correct terminals for your electrical supply type. Check that the links are correctly fitted and that the terminal screws are tight.

Replace the electric terminal cover box, making sure that the conduit is clear of the bottom flange.

Main Oven Light

Press the light switch in the main oven and check that the light is working.

NB. The oven light bulb is not included in the guarantee.

Hotplate

Check each burner in turn.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents User Guide for Australia Contents Before you start This appliance is heavy, so take care when moving it CleaningCooker Overview Hotplate Burners Griddle Medium/low Wok CradleHigh/medium Glide-out Grill Never close the grill door when the grill is onRight Hand Tall Oven OvensLeft Hand Oven Timer Setting the time of dayClock To stop the ovens at a specific time of dayKey Lock Multi-Function OvenAuto is showing, but you want to revert to manual cooking Pre-heat this function before cooking Multi-Function Oven FunctionsHandyrack Main Oven Tips on Cooking with the TimerFish Oven Cooking chart Conventional and Fan OvensLeft Hand Main Oven General Oven TipsOven Shelves Main Oven Light Cleaning your CookerHotplate Burners Essential InformationControl Panel and Doors GrillMain Oven Wok CradleTall Oven TroubleshootingHotplate burners will not light Hotplate ignition or hotplate burners faultyIf you have a problem Service and SparesOut of Warranty Please noteInstallation Side clearances Measurements B & C Overhead Measurement aMoving the Cooker Unpacking the CookerLowering the Two Rear Rollers Side clearances Measurement EConversion to LP Repositioning the Cooker following ConnectionLevelling Fitting the Handles and Front HandrailFitting the Stability Bracket Fitting the SplashbackFitting the Restraining Chain Gas ConnectionTap Adjustment Pressure testing for Natural GasConversion from Natural Gas to LP Gas JetsStick on label Propane Pressure TestingElectrical Connection Fitting the Plinth Oven CheckCustomer Care Thank youServicing Notes To Replace the Grill Controller To Replace a ThermostatTo Change a Hotplate Tap To Replace a Hotpate Burner JetTo Change the Main Oven Door Catch To Remove an Oven Inner Back To Change Ignition GeneratorTo Replace an Oven Fan To Replace an Oven Fan ElementTop Element To Adjust the Main Oven Door AngleCircuit Diagram Technical Data Australia Australia Australia
Top Page Image Contents