Falcon U109635-02 manual General Oven Tips, Oven Shelves, Left Hand Main Oven

Page 15

General Oven Tips

The wire shelves in an oven should always be pushed firmly to the back of the oven.

Baking trays, roasting tins, etc., should be placed level in the middle of the oven’s wire shelves. Keep all trays and containers away from the sides of the oven - otherwise, overbrowning of the food may occur.

For even browning, the maximum recommended size of a baking tray is 340mm by 340mm for the left hand (main) oven, and 230mm by 320mm for the right hand (tall) oven.

Food is cooked at lower temperature in a fan oven than in a conventional oven. When using recipes, reduce the temperature by 10°C and the cooking time by 5-10 minutes. The temperature in the fanned oven does not vary with height in the oven - so you can use any shelf.

The shelves should not be fitted directly one above the other. When cooking on more than one shelf always leave at least one runner space between them.

Australia

Oven Shelves

Left Hand (Main) Oven

The shelf guard should be at the back pointing upwards

As well as the flat shelf, some models are supplied with a drop shelf, which increases the spacing possibilities:

Always leave a ‘finger's width’ between dishes on the same shelf. This allows the heat to circulate freely around them.

The Cook & Clean oven panels (see 'Cleaning your Cooker') work better when fat splashes are avoided. Cover meat when cooking.

To reduce fat splashing when you add vegetables to hot fat around a roast, dry them thoroughly or brush lightly with cooking oil.

If you want to brown the base of a pastry dish, preheat a baking tray for 15 minutes before placing the dish in the centre of the tray.

Where dishes may boil and spill over during cooking, place them on a baking tray.

You can easily remove and refit the oven shelves, as follows:

Pull the shelf forward until the back of the shelf is stopped by the shelf stop bumps in the oven sides.

Lift up the front of the shelf so the back of the shelf will pass under the shelf stop and then pull the shelf forward:

To refit the shelf, line up the shelf with a groove in the oven side and push the shelf back until the ends hit the shelf stop. Lift up the front so that the shelf ends clear the shelf stops, and then lower the front so that the shelf is level, and push it fully back.

15

Image 15
Contents User Guide for Australia Contents Before you start This appliance is heavy, so take care when moving it CleaningCooker Overview Hotplate Burners Griddle Wok Cradle High/mediumMedium/low Glide-out Grill Never close the grill door when the grill is onOvens Left Hand OvenRight Hand Tall Oven To stop the ovens at a specific time of day Setting the time of dayTimer ClockMulti-Function Oven Auto is showing, but you want to revert to manual cookingKey Lock Pre-heat this function before cooking Multi-Function Oven FunctionsHandyrack Main Oven Tips on Cooking with the TimerFish Oven Cooking chart Conventional and Fan OvensGeneral Oven Tips Oven ShelvesLeft Hand Main Oven Essential Information Cleaning your CookerMain Oven Light Hotplate BurnersWok Cradle GrillControl Panel and Doors Main OvenTall Oven TroubleshootingHotplate burners will not light Hotplate ignition or hotplate burners faultyPlease note Service and SparesIf you have a problem Out of WarrantyInstallation Side clearances Measurements B & C Overhead Measurement aSide clearances Measurement E Unpacking the CookerMoving the Cooker Lowering the Two Rear RollersFitting the Handles and Front Handrail Repositioning the Cooker following ConnectionConversion to LP LevellingFitting the Stability Bracket Fitting the SplashbackFitting the Restraining Chain Gas ConnectionJets Pressure testing for Natural GasTap Adjustment Conversion from Natural Gas to LP GasPropane Pressure Testing Electrical ConnectionStick on label Thank you Oven CheckFitting the Plinth Customer CareServicing Notes To Replace a Hotpate Burner Jet To Replace a ThermostatTo Replace the Grill Controller To Change a Hotplate TapTo Change the Main Oven Door Catch To Replace an Oven Fan Element To Change Ignition GeneratorTo Remove an Oven Inner Back To Replace an Oven FanTop Element To Adjust the Main Oven Door AngleCircuit Diagram Technical Data Australia Australia Australia