Australia
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
3. Side clearances - Measurement E
Where D, the distance from the periphery of the nearest burner to a horizontal combustible surface is less than
200 mm, then E shall be 10 mm or more, or the horizontal surface shall be above the trivet. See insets above.
We recommend a gap of 1110mm between units to allow for moving the cooker. If a flush fit is required, fit the cooker up to the unit at one side then fit the unit the other side.
A clearance of 130mm is required if the cooker is near a corner of the kitchen, to allow the oven doors to open.
Do not box the cooker in - it must still be possible to move it in and out for cleaning and servicing.
For safety reasons, curtains,must not be fitted immediately behind the cooker.
A clearance of 130mm is required if the cooker is near a corner of the kitchen, to allow the oven doors to open. The actual opening of the doors is slightly less, but this allows for some protection of your hand as you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly in front of the location where is to be installed (unless it will not fit through a door in its outer packaging). Cut the banding straps and lift the cardboard box off the cooker, leaving the cooker standing on the base packaging. See the loose unpacking sheet.
Moving the Cooker
On no account try and move the cooker while it is plugged into the electricity supply.
The cooker is very heavy, and great care needs to be taken. We recommend that two people manoeuvre it. Ensure that the floor covering is firmly fixed, or removed, to prevent it being disturbed when moving the cooker around.
To help you, there are two levelling rollers at the back, and two
Remove the polystyrene base pack. From the front, tilt the cooker forward and remove the front half of the polystyrene base:
Repeat from the back and remove the rear half of the polystyrene base.
Lowering the Two Rear Rollers
Firstly, fit the levelling tool on the hexagonal adjusting nut, as shown below:
Make 10 complete (360º) turns clockwise. (This means turning and removing the levelling tool 20 times).
23