Falcon U109988 - 02 Completing the Move, Repositioning the Cooker following Connection, Levelling

Page 22

INSTALLATION

Check the appliance is electrically safe when you have finished.

Fig.6-5

ArtNo.010-0002 Rear roller nut

Fig.6- 6

ArtNo.010-0010 Lowering the rear rollers (90)

x10

Fig.6-7

ArtNo.010-0009 Pushing the cooker

Fig.6-8

ArtNo.010-0004 Moving the cooker

Lower the Two Rear Rollers

First fit the levelling tool on the hexagonal adjusting nut (Fig.6-5).

Make 10 complete (360°) turns clockwise (Fig.6-6). (This means turning and removing the levelling tool 20 times.)

Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker.

Completing the Move

Unfold the rear edge of the pack base tray. Open the grill door and right-hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the cooker.

Grip under the fascia panel and lift the front of the cooker slightly (Fig.6-7).

Carefully push the cooker backwards off the pack base. Remove the pack base tray. Position the cooker close to its final position, leaving just enough space to get behind it.

DO NOT use the door handles or control knobs to manoeuvre the cooker.

Repositioning the Cooker following Connection

If you need to move the cooker once it has been connected, make sure it is switched off at the supply switch before gripping under the fascia panel and lifting the front of the cooker slightly (Fig.6-8). Check behind the cooker to ensure that the electricity cable is not caught. As you progress, always ensure that the cable has sufficient slack to allow the cooker to move.

If a stability chain is fitted, release it as you ease the cooker out. Do not forget to refit it when you replace the cooker.

When you replace the cooker, check behind it again once more to ensure that the electricity cable is not caught or trapped.

Levelling

It is recommended that you use a spirit level on a shelf in one of the ovens to check for level.

Place the cooker in its intended position. Take care not to twist it within the gap between the kitchen units, as otherwise, damage may occur to the cooker or units.

The front feet and rear rollers can be adjusted to level the cooker. To adjust the height of the rear of the cooker, use the levelling tool supplied to turn the roller adjusting nuts at the front bottom corners of the cooker. To raise or lower the feet, simply turn the disks that are fitted onto them.

Fitting the Handles

To fit the handles, first remove the 4mm Allen screws from the doors. Locate the door handles to the doors, making sure that the handles are above the fittings, and secure in position

20

Image 22
Contents User Guide Contents Before You Start Installation and MaintenancePersonal Safety VentilationCooker Care CleaningHob Care  do not use the hob surface as a cutting boardCooker Overview HobPan Detector Residual Heat Indicator, HAutomatic Heat-up, a Pan Protection Function Glide-out GrillChild Lock, L 0Fig.2-8Left-Hand Multi-function Oven  Never close the grill door when the grill is onOvens Multi-function oven functionsFan assisted oven Fan ovenFanned grilling Conventional oven top and base heatRight-hand tall oven Operating the OvensClock Setting the time of dayTo start and then stop the left-hand oven using the Timer Minute MinderKey Lock AccessoriesAuto is showing, but you want to revert to manual cooking Oven Shelves Left-hand Main OvenOven shelves Right-hand Tall Oven Main Oven LightHandyrack Main Oven Cooking Tips Tips on Cooking with the TimerGeneral Oven Tips Cleaning Burned-on Spills Cleaning Your CookerCleaning Spills Daily Care‘Cook & Clean’ Panels Control Panel and DoorsRemoving the Panels to clean the Enamel Interior Tall OvenTroubleshooting Oven temperature getting hotter as the cooker gets older Timed oven is not coming on when turned on manuallyTimed oven is not coming on when automatic cooking Food is cooking too slowly, too quickly, or burningSafety Requirements InstallationDear Installer Provision of VentilationUnpacking the Cooker Positioning the CookerMoving the Cooker Levelling Completing the MoveRepositioning the Cooker following Connection Fitting the HandlesHob Check Fitting the Splashback optionalElectrical Connection Grill CheckServicing To Replace an Oven Door To Adjust an Oven Door AngleTo Remove Grill Element  The door is heavy, so take careTo Change the Main Oven Door Latch To Adjust the Main Oven Door Catch KeepTo Replace the Tall Oven Door Outer Panel To Replace an Oven Door SealTo Remove the Left-hand Oven Bottom and Top Elements To Replace an Oven FanTo Change Oven Light Bulb Key Circuit Diagram OvenCode Description Colour Code Circuit Diagram Hob Dimensions Technical DataConnections Français Odeur de neuf Installation et EntretienAvant de commencer… Sécurité personnelleFrançais Conseils relatifs à la table de cuisson NettoyageVue d’ensemble de la Cuisinière Table de cuissonIndicateur de chaleur résiduelle, H Détection de récipient de cuissonTableau Verrouillage sécurité enfants, L Chauffage automatique, aProtection de récipient de cuisson Four gauche Gril Coulissant Glide-outFours Fonctions du four multifonctionsGril ventilé Four ventiléFour ventilé mixte Four droit Fonctionnement des foursMinuterie HorlogeRéglage de l’heure Arrêt automatique du four gaucheActivation de la fonction de verrouillage Fonction de verrouillageGrilles de four Four gauche four principal Désactivation de la fonction de verrouillageGrilles de four Four droit four haut Eclairage du FourHandyrack Conseils pour la Cuisson Conseils généraux pour la cuisson au fourEntretien Quotidien Nettoyage de la CuisinièreInformations importantes Nettoyage des Déversements AccidentelsGril Coulissant Nettoyage des Déversements BrûlésFour Haut Panneau de Commande et PortesPanneaux autonettoyants Dépannage Le four ne s’allume pas La cuisson au four n’est pas uniforme’éclairage du four ne fonctionne pas Prescriptions de Sécurité ’intention de l’installateurEmplacement de la Cuisinière Positionnement de la CuisinièreDéplacement de la Cuisinière Déballage de la CuisinièreRepositionnement de la Cuisinière après Raccordement Abaissement des Deux Galets ArrièrePositionnement Final Mise à NiveauContrôle de la Table de Cuisson Montage des poignéesRaccordement Électrique Contrôle du grilRemplacement d’un élément de table de cuisson EntretienRemplacement d’un regulateur de gril Remplacement de l’interrupteur d’éclairageRemplacement d’un thermostat Remplacement d’une porte de fourRemplacement d’un joint de porte de four Remplacement du verrouillage de porte principale de four19. Dépose d’un protecteur thermique d’element de four 21. Dépose de l’element du four ventile Remplacement de l’ampoule d’éclairage du four20. Dépose de la partie arriere interne du four 22. Dépose du ventilateur du fourLégende Schéma de câblage FoursCode Elément Couleur Schéma de câblage Table de cuisson Puissances Fiche techniqueRaccordments ElectricitéArtNo.000-0001 Aga address block