Falcon U109988 - 02 manual Servicing

Page 24

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

7. Servicing

DocNo.081-0013GB - Servicing - 90 induction - Elan

Disconnect the cooker from the electricity supply before servicing, particularly before removing any of the following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes.

Before reconnection, check that the appliance is electrically safe.

1.To Remove a Side Panel

Disconnect from electricity supply.

Pull the cooker forward. Remove the fixing screws.

Remove the retaining screws for each panel (one at the front, two at the rear, and one at each lower front corner of the side panels).

Reassemble in reverse order.

5.To Replace the Light Switch

Disconnect from electricity supply. Remove the control panel (see 1).

Note: The old switch may be destroyed during removal. Remove the old switch from its bezel by gripping the switch body behind the control panel and twisting sharply. Remove the switch bezel by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the cut-out in the control panel and pushing it in from the front.

Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.

Replace the Control Panel in reverse order and test for correct operation.

2.To Lift up the Ceramic Hob

Disconnect from electricity supply.

Remove the blanking plugs at the top front of each of the side panels to allow access to the hob fixing screws (1 each side) at the top of the side uprights. Remove these screws.

Lift up the ceramic hob at the front and prop in position with a non-metallic prop.

CAUTION: The ceramic hob material is much more sensitive to scratches on the underside than the top.

Take care not to touch or scratch the underside of the ceramic as this will weaken the material and cause the top to shatter.

6.To Remove the Electronic Timer

Disconnect from electricity supply.

Remove the control panel (see 1). Pull off the timer control button(s).

Remove the timer/mounting bracket assembly from the control panel by removing the fixing screws.

Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.

Reassemble in reverse order. When replacing the leads, refer to the wiring diagram in this manual. Check the operation of the timer.

3.To Remove the Control Panel

Disconnect from electricity supply.

Remove the two blanking plugs from the handrail fixing brackets. Remove the handrail by unscrewing the 2 end bracket fixing screws (Fig.7-1).

Pull off all the control knobs. Open the grill and right-hand oven door and remove the control panel fixing screws underneath the control panel. The screws directly below the clock are for the clock fixing bracket, so do not remove them at this stage.

Lift the control panel, pull forward and disconnect the wiring from the rear.

Reassemble in reverse order. When replacing leads, refer to the wiring diagram in this manual. Check the operation of the timer.

4.To Replace a Hob Element

Disconnect from electricity supply.

Lift up the ceramic hob (see 2). The Induction Heating Elements (IHE) are now accessible. Note the wire connection positions and element orientation for re-assembly. Disconnect the wires, and remove the element unit and springs. Re- assemble in the reverse order.

Note: The IHE will require commissioning when the hob has been refitted.

7.To Replace a Thermostat

Disconnect from the electricity supply.

Remove control panel (see 1) and lift hob (see 3). Open the oven door. Remove the oven furniture and slide out the oven roof liner if fitted.

For the right-hand oven, remove the thermostat phial cover (two screws). Unclip the thermostat phial from the clips in the oven back.

For the left-hand oven, pull cooker forward to gain access to the cover box at the rear of the cooker. Remove the four screws securing the cover and lift clear.

Feed the thermostat capillary out of the oven. Disconnect the wiring from the thermostat. Remove two screws holding thermostat to mounting panel. Fit new thermostat and reassemble in reverse order. Ensure that the phial is clipped to the oven back with the phial centrally positioned between the clips.

Check the operation of the thermostat.

8.To Replace the Grill Controller

Disconnect from electricity supply.

Remove the control panel and lift up the hob (see 1 and 3). Disconnect the wiring from the controller. Remove the two screws holding the controller to the mounting panel. Fit the new controller and reassemble in reverse order. Check for correct operation.

22

Page 23 Page 25
Image 24
Page 23 Page 25
Contents User Guide Contents Installation and Maintenance Personal SafetyBefore You Start VentilationCleaning Hob CareCooker Care  do not use the hob surface as a cutting boardCooker Overview HobResidual Heat Indicator, H Pan DetectorAutomatic Heat-up, a Glide-out Grill Child Lock, LPan Protection Function 0Fig.2-8 Never close the grill door when the grill is on OvensLeft-Hand Multi-function Oven Multi-function oven functionsFan oven Fanned grillingFan assisted oven Conventional oven top and base heatRight-hand tall oven Operating the OvensSetting the time of day To start and then stop the left-hand oven using the TimerClock Minute MinderAccessories Auto is showing, but you want to revert to manual cookingKey Lock Oven Shelves Left-hand Main OvenMain Oven Light Oven shelves Right-hand Tall OvenHandyrack Main Oven Tips on Cooking with the Timer Cooking TipsGeneral Oven Tips Cleaning Your Cooker Cleaning SpillsCleaning Burned-on Spills Daily Care‘Cook & Clean’ Panels Control Panel and DoorsRemoving the Panels to clean the Enamel Interior Tall OvenTroubleshooting Timed oven is not coming on when turned on manually Timed oven is not coming on when automatic cookingOven temperature getting hotter as the cooker gets older Food is cooking too slowly, too quickly, or burningInstallation Dear InstallerSafety Requirements Provision of VentilationPositioning the Cooker Unpacking the CookerMoving the Cooker Completing the Move Repositioning the Cooker following ConnectionLevelling Fitting the HandlesFitting the Splashback optional Electrical ConnectionHob Check Grill CheckServicing To Adjust an Oven Door Angle To Remove Grill ElementTo Replace an Oven Door  The door is heavy, so take careTo Adjust the Main Oven Door Catch Keep To Replace the Tall Oven Door Outer PanelTo Change the Main Oven Door Latch To Replace an Oven Door SealTo Replace an Oven Fan To Remove the Left-hand Oven Bottom and Top ElementsTo Change Oven Light Bulb Circuit Diagram Oven KeyCode Description Colour Code Circuit Diagram Hob Technical Data DimensionsConnections Français Installation et Entretien Avant de commencer…Odeur de neuf Sécurité personnelleFrançais Conseils relatifs à la table de cuisson NettoyageVue d’ensemble de la Cuisinière Table de cuissonDétection de récipient de cuisson Indicateur de chaleur résiduelle, HTableau Chauffage automatique, a Verrouillage sécurité enfants, LProtection de récipient de cuisson Gril Coulissant Glide-out FoursFour gauche Fonctions du four multifonctionsFour ventilé Gril ventiléFour ventilé mixte Four droit Fonctionnement des foursHorloge Réglage de l’heureMinuterie Arrêt automatique du four gaucheFonction de verrouillage Grilles de four Four gauche four principalActivation de la fonction de verrouillage Désactivation de la fonction de verrouillageEclairage du Four Grilles de four Four droit four hautHandyrack Conseils pour la Cuisson Conseils généraux pour la cuisson au fourNettoyage de la Cuisinière Informations importantesEntretien Quotidien Nettoyage des Déversements AccidentelsGril Coulissant Nettoyage des Déversements BrûlésPanneau de Commande et Portes Four HautPanneaux autonettoyants Dépannage La cuisson au four n’est pas uniforme Le four ne s’allume pas’éclairage du four ne fonctionne pas ’intention de l’installateur Emplacement de la CuisinièrePrescriptions de Sécurité Positionnement de la CuisinièreDéplacement de la Cuisinière Déballage de la CuisinièreAbaissement des Deux Galets Arrière Positionnement FinalRepositionnement de la Cuisinière après Raccordement Mise à NiveauMontage des poignées Raccordement ÉlectriqueContrôle de la Table de Cuisson Contrôle du grilRemplacement d’un élément de table de cuisson EntretienRemplacement de l’interrupteur d’éclairage Remplacement d’un thermostatRemplacement d’un regulateur de gril Remplacement d’une porte de fourRemplacement du verrouillage de porte principale de four Remplacement d’un joint de porte de four19. Dépose d’un protecteur thermique d’element de four Remplacement de l’ampoule d’éclairage du four 20. Dépose de la partie arriere interne du four21. Dépose de l’element du four ventile 22. Dépose du ventilateur du fourSchéma de câblage Fours LégendeCode Elément Couleur Schéma de câblage Table de cuisson Fiche technique RaccordmentsPuissances ElectricitéArtNo.000-0001 Aga address block
Top Page Image Contents